Abstract:Molecular dynamics simulations are performed to study the mechanical properties and deformation mechanisms of a heterogeneous face-centered cubic/ body-centered cubic Cu/Ta nanolayered composite under uniaxial tension and compression. The results show that the stress-strain curves exhibit two main yield points in tension while only one yield point during compression, and the deformation primarily experiences three stages. The first stage is linearly elastic at small strains, followed by the nucleation and propagation of dislocations and stacking faults in the Cu layers, and eventually the Ta layers yield to plastic deformation. The yield of the specimen is mainly determined by the dislocation evolution in the hard phase (i.e. Ta layers), which leads to a sharp drop in the stress-strain curve. We show that the heterogeneous nanolayered composite exhibits a good deformation compatibility during compression but an obvious deformation incompatibility between Cu and Ta layers in tension. The temperature effect is also systematically investigated. It is revealed that the yield of the specimen at higher temperature depends only on the dislocation evolution in the thick Ta layers, and the yield strengths in tension and compression both decrease with the increasing temperature. In particular, our computations show that high temperature can significantly suppress the dislocation activities in the Cu layers during deformation, which results in a lower dislocation density of the Cu layers compared with that of the Ta layers and thus causing an incompatible fashion among the constituent layers.

Evolution of residual stress and interface coherency and their impact on deformation mechanisms in Al/Ti multilayers

Deformation Mechanisms Dominated by Decomposition of an Interfacial Misfit Dislocation Network in Ni/Ni3Al Multilayer Structures

Influence of interface on deformation compatibility of a heterogeneous Cu/Al nanoscale multilayer

The effect of interface structures on deformation behavior of Cu/Ni multilayer by molecular dynamics

In-situ EBSD study of the multiple deformation modes of a TiNb/Nb/NiTi multilayer composite

Coherent-interface-induced second hardening deformation of Al–Mg–Al nanolayers by molecular dynamics simulations

Molecular dynamics simulations of interface structure and deformation mechanisms in metal/ceramic composites under tension

A molecular dynamics investigation into deformation mechanism of nanotwinned Cu/high entropy alloy FeCoCrNi nanolaminates

Interface-Driven Plasticity in Metal–Ceramic Nanolayered Composites: Direct Validation of Multiscale Deformation Modeling via In Situ Indentation in TEM

Unraveling hot deformation behavior and microstructure evolution of nanolamellar TiAl/Ti3Al composites

Nanostructure, Plastic Deformation, and Influence of Strain Rate Concerning Ni/Al2O3 Interface System Using a Molecular Dynamic Study (LAMMPS)

Effect of layer thickness on mechanical properties of Cu/CoCrFeNi nanolaminates: Implications from a quantitative flow stress model

Alloy strengthening toward improving mechanical and tribological performances of Cu x Ni 100−x /Ta nano multilayer materials

Ultra-high strength and plasticity mediated by partial dislocations and defect networks: Part II: Layer thickness effect

Atomic-scale deformation mechanisms of nano-polycrystalline Cu/Al layered composites: a molecular dynamics simulation

Interfacial Structures Governed Plastic Deformation Behaviors in Metallic Multilayers

Residual stress analysis in the Al2O3/Ti 3SiC2 multilayer composites

Revealing thickness dependence of hardness, strain rate sensitivity, and creep resistance of nano-crystalline magnesium/titanium multilayers by nanoindentation

Stable strain hardening behavior of Ti-4Al-5Mo-5V-5Cr-1Nb alloy during plastic deformation

Atomistic simulations of mechanical response of a heterogeneous fcc/bcc nanolayered composite

Molecular dynamics studies of the effect of intermediate Fe layer thickness on the enhanced strength and ductility of Cu/Fe/Ni multilayer