Abstract:Charge accumulation on a solid insulator surface is one of the critical factors for the development of dc gas-insulated equipment since it will lead to the overstress of polymeric insulation due to local field distortion and enhancement. Therefore, it is significant to study the charge accumulation phenomenon on spacer surface under dc field. However, it remains an important subject to obtain the accurate results of surface charge distribution. Electrostatic probe method was used to measure the surface potential distribution of a cone-shaped spacer in a downsized gas-insulated line (GIL) and the inverse calculation method of the surface charge distribution, especially for this “shift-variant” configuration, was investigated. Numerical simulation was used to obtain the transfer matrix from charge density to the probe output. By a signal processing technique based on the Wiener filter, the ill-condition problem of the matrix was solved and the stability of the calculation was improved. The study also analyzed the spatial resolution and accuracy of the calculation results, which shows that the spatial resolution of the system can reach 1.8 mm. Based on the above method, we studied the charge accumulation phenomena of the epoxy spacer under dc voltage in air and SF6. The results show that there are two patterns in the charge distribution: “dominant uniform charging” and random “charge speckles”. The uniform charging was of the same polarity as the applied voltage, which indicates current flow from the solid bulk is the dominate mechanism in surface charging.

Charge Distribution Dependency on Gap Thickness of CMS Endcap RPC

Numerical study of effects of electrode parameters and image charge on the electric field configuration of RPCs

Measurement of Avalanche Size and Position Resolution of Rpcs with Different Surface Resistivities of the High Voltage Provider

Gas Magnification Of Multi-Gap Resistive Plate Chamber

Study on the Physical Mechanism in Multi-Gap Resistive Plate Chamber

Studies on RPC Position Resolution with Different Surface Resistivity of High Voltage Provider

Production and the Quality Control for the CMS Endcap RPCs

Numerical study of space charge electric field inside Resistive Plate Chamber

Performance study of large-area glass resistive plate chambers with different spacer configurations

Development of Multi-Gap Resistive Plate Chambers with Low-Resistive Silicate Glass Electrodes for Operation at High Particle Fluxes and Large Transported Charges

Measurements of the Rate Capability of Various Resistive Plate Chambers

Study of an avalanche-mode resistive plate chamber

A Method to Estimate Gas Magnification of Multi-Gap Resistive Plate Chamber

Numerical simulation of the response of single gap timing RPCs with the space charge effects and Garfield++

Gap Uniformity Study of a Resistive Micromegas for the Multi-purpose Time Projection Chamber (MTPC) at Back-n White Neutron Source

Prototype study of $0.1\%\,X_0$ and $\mathrm{MHz/cm^2}$ tolerant Resistive Plate Chamber with Diamond-Like Carbon electrodes

Influence Of Gap Spacing On The Characteristics Of Trichel Pulse Generated In Point-To-Plane Discharge Gaps

Improving the RPC rate capability

Influence of electrode thickness on rate capability of MRPC

Measurement Method and Accumulation Characteristics of Surface Charge Distribution on Polymeric Material under DC Voltage

Gas related effects on multi-gap RPC performance in high luminosity experiments