Design method of rack-and-pinion pair with pure rolling variable transmission ratio
Niu Ziru,Xin Shuai,Liu Fuhui,Zou Liangliang,Xin Zhenbo,Liu Xinghua,Yuan Jin
DOI: https://doi.org/10.1177/09544062241230201
2024-02-22
Proceedings of the Institution of Mechanical Engineers Part C Journal of Mechanical Engineering Science
Abstract:Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, Ahead of Print. Rack-and-pinion pair with variable transmission ratio can achieve the unity of vehicle steering portability and sensitivity, and effectively reduce vehicle steering energy consumption. Therefore, they have gradually become the standard core components of steering system. However, the gear surface of rack-and-pinion pair with variable transmission ratio is seriously worn under long-term service, which leads to the degradation of performance and cannot achieve the theoretically variable transmission ratio. To solve these problems, a new configuration of rack-and-pinion pair for commercial vehicle with herringbone pure rolling variable transmission ratio is proposed in this paper. The tooth surface mathematical model of the fully-conjugate variable transmission ratio is established based on the variable speed envelope principle, and the formula for calculating pure rolling point of tooth surface with variable transmission ratio is derived. The tooth point deviation equation of fully-conjugate variable transmission ratio is proposed, and the method of constructing pure rolling variable transmission ratio tooth surface is formed. The finite element analysis shows that the design of the pure rolling rack-and-pinion pair with variable transmission ratio has good tooth surface quality without the phenomenon of contact spot intermittent and edge contact during the meshing process, and the contact ellipse center of the tooth surface is located at the theoretical pure rolling point of the tooth surface. The measured transmission ratio curve of the samples is in good agreement with the theoretical variable transmission ratio curve, and the transmission ratio error is within a reasonable range. The contact strips of tooth surface impression test are consistent with those of finite element analysis, which indicates that the designed rack-and-pinion pair with variable transmission ratio has the characteristics of pure rolling and point contact. The tooth surface wear test shows that the wear of pure rolling gear surface with variable transmission ratio is obviously less than that of traditional gear surface with variable transmission ratio. The above tests and simulation indicate the correctness of the design method.
engineering, mechanical