Abstract:Future large tokamaks will operate at high plasma currents and high stored plasma energies. To ensure machine protection in case of a sudden loss of plasma confinement (major disruption), a large fraction of the magnetic and thermal energy must be radiated to reduce thermal loads. The disruption mitigation system for ITER is based on massive material injection in the form of shattered pellet injection (SPI). To support ITER, a versatile SPI system was installed at the tokamak ASDEX Upgrade (AUG). The AUG SPI features three independent pellet generation cells and guide tubes, and each was equipped with different shatter heads for the 2022 experimental campaign. We dedicated over 200 plasma discharges to the study of SPI plasma termination, and in this manuscript report on the results of bolometry (total radiation) analysis. The amount of neon inside the pellets is the dominant factor determining the radiated energy fraction (frad). Large and fast fragments, produced by the $12.5^\circ$ rectangular shatter head, lead to somewhat higher values of frad compared to the $25^\circ$ circular or rectangular heads. This effect is strongest for neon content of $< 4\times10^{20}$ neon atoms injected, where a higher normal velocity component (larger fragments) seems slightly beneficial. While full-sized, 8 mm diameter, pure deuterium (D2) pellets lead to a disruption, the 4 mm or shortened 8 mm pellets of pure D2 did not lead to a disruption. The disruption threshold for pure D2 is found to be around $1\times10^{22}$ deuterium molecules inside the pellet. While the radiated energy fraction of non-disruptive SPI is below 20%, this is increased to 40% during the TQ and VDE phase of the disruptive injections. For deuterium-neon-mix pellets, frad values of $< 90$% are observed, and the curve saturates around 80% for 10% neon mixed into the 8 mm pellets ($2\times10^{21}$ neon atoms).

Pellet refuelling of particle loss due to ELM mitigation with RMPs in the ASDEX Upgrade tokamak at low collisionality

Pellet fuelling of plasmas with ELM mitigation by resonant magnetic perturbations in MAST

Non-linear shattered pellet injection modelling in ASDEX Upgrade

Pellet fuelling with edge-localised modes controlled by external magnetic perturbations in MAST

Assimilation of impurities during massive gas injection in ASDEX Upgrade

Density Compensation with Pellet Fueling During ELM Suppression with N = 4 RMP on Metal-Wall EAST Tokamak

Fuelling of deuterium-tritium plasma by peripheral pellets in JET experiments

Reduced kinetic modelling of shattered pellet injection in ASDEX Upgrade

Design of the shattered pellet injection system for ASDEX Upgrade

MHD simulations of small ELMs at low triangularity in ASDEX Upgrade

Radiated energy fraction of SPI-induced disruptions at ASDEX Upgrade

Comparing spontaneous and pellet-triggered ELMs via non-linear extended MHD simulations

Overview of ASDEX Upgrade results in view of ITER and DEMO

MHD simulations of formation, sustainment and loss of Quiescent H-mode in the all-tungsten ASDEX Upgrade

Numerical Simulation of Fueling Pellet Ablation and Transport in the EAST H-mode Discharge

Deuterium Pellet Fueling in Type-Iii ELMy H-mode Plasmas on EAST Superconducting Tokamak

Modelling of shattered pellet injection experiments on the ASDEX Upgrade tokamak

Inter-discharge optimization for fast, reliable access to ASDEX Upgrade advanced tokamak scenario

Self-consistent modeling of runaway electron generation in massive gas injection scenarios in ASDEX Upgrade

Pedestal structure and inter-ELM evolution for different main ion species in ASDEX Upgrade

Operational Space and Plasma Performance with an RMP-ELM Suppressed Edge