Abstract:Nb3Sn conductors are important candidates for high-field magnets for particle accelerators, and they continue to be widely used for many laboratory and NMR magnets. However, the critical current density, Jc, of present Nb3Sn conductors declines swiftly above 12-15T. State-of-the-art Ta- and Ti-doped strands exhibit upper critical field, Hc2, values of 24-26.5T (4.2K) and do not reach the FCC target Jc, which serves as the present stretch target for Nb3Sn development. As recently demonstrated, to meet this goal requires enhanced vortex pinning but an independent and supplementary approach is to significantly enhance Hc2. In this study, we have arc-melted multiple Nb alloys with added Hf, Zr, Ta and Ti and drawn them successfully into monofilament wires to investigate the possibilities of Hc2 enhancement through alloying. Hc2(T) was measured for all samples in fields up to 16T and some up to 31T. We have found that all alloys show good agreement with the standard Werthamer, Helfand, and Hohenberg (WHH) fitting procedure without the need to adjust the paramagnetic limitation parameter (alpha) and spin-orbit scattering parameter (lambda_so). The evaluation of dHc2/dT near Tc, which is proportional to the electronic specific heat coefficient (gamma) and the normal state resistivity (rho_n), allows a better understanding of the induced disorder introduced by alloying in the A15 phase. So far, we have observed that Hf alloying of pure Nb can enhance Hc2(0) by 3-4T to 28T, while adding just 1 at. %Hf or Zr into a Nb4Ta base alloy can raise Hc2(0) to 31T. Very importantly we find that Hf and Zr raise the alloy recrystallization temperature above the usual A15 reaction temperature range of 650°C-750°C, thus ensuring denser A15 phase nucleation in the Nb alloy grain boundaries, possibly leading to a more homogeneous A15 phase Sn content and refined A15 grain size. The potential for...

Performance Boost in Industrial Multifilamentary Nb3Sn Wires due to Radiation Induced Pinning Centers

Effects of Neutron Irradiation on Pinning Force Scaling in State-of-the-Art Nb3Sn Wires

Achievement of FCC specification in critical current density for Nb3Sn superconductors with artificial pinning centers

Internal Strain Measurement by Neutron Diffraction Under Transverse Compressive Stress for Nb 3 Sn Wires With and Without Cu-Nb Reinforcement

Flux pinning dynamics in optimally proton irradiated REBCO coated conductors

Determination of the electromechanical limits of high-performance Nb$_3$Sn Rutherford cables under transverse stress from a single-wire experiment

[P67] Isothermal Section of the Ti-Nb-Sn Ternary System at 700 °C

Effect of Nb3Sn Coarse Grains on Critical Current Densities of Internal Tin Nb3Sn Strand

Critical currents and pinning mechanism of superconducting Nb-50% wt Ti Alloys

Influence of Nb Alloying on Nb Recrystallization and the Upper Critical Field of Nb3Sn

Critical current anisotropy in Nd-1111 single crystals and the infuence of neutron irradiation

Internally Oxidized Nb3Sn Strands with Fine Grain Size and High Critical Current Density

Ta, Ti and Hf effects on Nb$_3$Sn high-field performance: temperature-dependent dopant occupancy and failure of Kramer extrapolation

Experimental verification of the temperature and strain dependence of the critical properties in Nb/sub 3/Sn wires

Tensile Properties and Microstructure of Zr–1.8Nb Alloy Subjected to 140-Mev C4+ Ion Irradiation

Beneficial influence of Hf and Zr additions to Nb4at.%Ta on the vortex pinning of Nb$_{3}$Sn with and without an O source

Improved critical current density of Cu-doped Nb3Al wire through optimized Rapid-Heating Quenching and Transformation method

Flux Pinning Effect of Cubic Equiaxed Morphology and Its Ti Stabilizing in Nb3Sn Superconductors

Effect of Cubic Equiaxed Grains and Its Ti-Stabilizing Performance in Nb3sn Strands

Enhancement Of Critical Current-Density In Fast-Neutron Irradiated Melt-Textured Yba2cu3o7-X

High-Field Critical Current Enhancement by Irradiation Induced Correlated and Random Defects in (Ba0.6k0.4)fe2as2