Abstract:It is demonstrated, for the first time, that solid state lasers based on optimal parametric oscillation (OPO) allow relatively rapid sequential multi-element analysis of samples by laser; excited atomic fluorescence spectrometry (LEAFS) in a graphite furnace, These lasers are tunable by facile computer keyboard control over the wavelength region 220-2000 nm. A method is described for the sequential multi element determination of cadmium, cobalt, lead, manganese and thallium in a river sediment standard reference material (NIST SRM 2704) by graphite furnace LEAFS. With a slew rate of 0.125 nm s(-1), the OPO laser could be tuned to cover the wavelength range needed for these elements, from 228 to 304 nm, in 15 min. This allowed each element to be determined sequentially with the analysis time determined primarily by the slow heating cycle of the furnace rather than the laser wavelength tuning. Detection limits in the multi-element made were 545, 111, 28, 445 and 24 fg for cadmium, cobalt, lead, manganese and thallium, respectively, limited primarily by the low repetition rate of the laser (10 Hz). The multi-element detection limits were within a factor of 2-4 of those in the single element made, Higher excitation energies, by a factor of 2-5, were required to optically saturate the transitions of the analytes in the sediment sample solution compared with aqueous standards. By use of several aliquots of one sample solution, and simple aqueous calibration, it was possible to analyze the sample, accurately, for the five elements over a concentration range between 1 ng ml(-1) for thallium and 460 ng ml(-1) for manganese. Different dilutions were not necessary owing to the long calibration range of the technique. The high sensitivity of LEAFS allowed sufficient initial dilution to remove an interference on thallium that is normally irresolvable by atomic absorption measurements of the same sample id the same graphite furnace.

Sub-parts-per-quadrillion-level graphite furnace atomic absorption spectrophotometry based on laser wave mixing

Laser Excited Atomic Fluorescence Spectrometry in A Graphite Furnace with an Optical Parametric Oscillator Laser for Sequential Multi-Element Determination of Cadmium, Cobalt, Lead, Manganese and Thallium in Buffalo River Sediment

Measurement of 7li/6li Isotope Ratio Using Phase-Conjugate Degenerate Four-Wave Mixing in a Graphite Furnace

A Compact Electrothermal-Flame Tandem Atomizer for Highly Sensitive Atomic Fluorescence Spectrometry

Expansion of Dynamic Range of Flame Atomic Absorption Spectrometry by an Efficient Flow Injection Dilution System Based on Dispersion of Microliter-Volume Samples

Direct Quantitative Analysis of Fluorine in Solid Samples by Cryogenic Laser Ablation and Ionization Time-of-Flight Mass Spectrometry.

Use of a furnace with a graphite filter for electrothermal atomic absorption spectrometry

Contribution of System Components to Dispersion in the Analysis of Microvolume Samples by Flow-Injection Flame Atomic-Absorption Spectrometry

High-repetition-rate laser ablation for elemental analysis in an inductively coupled plasma with acoustic wave normalization

Ultra-trace Rb detection with degenerate four-wave mixing in a graphite furnace

A new method to deconvolute binary mixture in LA-ICP-MS analyses to quantify the composition of phases smaller than the laser spot size

Synergetic Effect of Laser and Micro-Fabricated Glow Discharge Plasma in a New Ion Source for Ambient Mass Spectrometry.

A Novel Laser Ablation Chamber for Microwave Plasma Atomic Emission Spectrometry and Its Application

Determination of Se, Pb, and Sb by Atomic Fluorescence Spectrometry Using a New Flameless, Dielectric Barrier Discharge Atomizer

An Efficient Flow-Injection Online Dilution System for Flame Atomic-Absorption Spectrometry Based on Micro-Zone Penetration

Highly Sensitive Pneumatic Nebulization Flame Furnace Atomic Absorption Spectrometry: Complete Sample Aerosol Introduction and On-Line Preconcentration of Cadmium by Atom Trap

Approaching Standardless Quantitative Elemental Analysis of Solids: Microsecond Pulsed Glow Discharge and Buffer-Gas-Assisted Laser Ionization Time-of-Flight Mass Spectrometry

Low Temperature Hydrogen Plasma Assisted Chemical Vapor Generation for Atomic Fluorescence Spectrometry

A Miniature Lab-On-Valve Atomic Fluorescence Spectrometer Integrating A Dielectric Barrier Discharge Atomizer Demonstrated for Arsenic Analysis

Single-Shot Elemental Analysis of Liquids Based on Laser Vaporization at Fluences Below Breakdown

Standardless Semi-quantitative Elemental Analysis of Steel Using Laser Ablation Time-of-flight Mass Spectrometry