Abstract:This paper describes a novel hydride atomizer based on atmospheric pressure dielectric barrier discharge (DBD) plasma. The plasma was generated with a 3700-V, 20.3-kHz, and 5-W electrical power supply and easily sustained with inert gases (He or Ar) at a flow rate of 250 mL(.)min(-1) after optimization. However, it cannot be sustained with N-2. Ibis atomizer offers the advantages of low operation temperature and low power consumption in comparison with the currently used electrothermal quartz atornization operated at 900 degrees C with a power supply of several hundred watts. To confirm the utility of the proposed atomizer, four arsenic species (As(III), As(V), monomethylarsonic acid (MMA), dimethylarsinic acid (DMA)) were determined by the present atornization technique. A hyphenation of HPLC coupled to hydride generation AAS with the optimized DBD atomizer has been successfully used for the speciation of arsenic in order to demonstrate the potential of this atomizer in the present study. The characteristics of the DBD atomizer and the effects of different parameters (discharge gas, gas flow rate, voltage, HCl concentration, KBH4 concentration) are discussed in the paper. Compared with other hydride atornization techniques, the proposed method shows the following features: (1) small size (70 mm x 15 mm x 5 mm), which is preferable for the miniaturization of the total analytical system; (2) low power consumption (:55 W), which indicates the possibility of the development of portable, fieldable analytical instrumentation for in situ detection using battery as power supply; (3) low atomizer temperature (similar to 70 degrees C), which is in favor of the compactness of the total instruments; (4) avoidance of residue moisture removal in comparison with the existed GD system, which leads to the facility of the system. The analytical figures of the present technique were evaluated. The detection limits of As(III), As(V), MMA, and DMA obtained with HG-DBD-AAS were 1.0, 11.8, 2.0, and 18.0 mu g(.)L(-1), respectively. The accuracy of the system was verified by the determination of arsenic in reference material of orchard leaves SRM 1571,. The concentration of As determined by the present method agreed well with the reference values. The speciation of arsenic in the freeze-dried urine SRM 2670 were carried out, and the results obtained were in agreement with the results of HPLC-ICPMS and the reported values by other laboratories.

Determination of Se, Pb, and Sb by Atomic Fluorescence Spectrometry Using a New Flameless, Dielectric Barrier Discharge Atomizer

Application of atmospheric pressure dielectric barrier discharge plasma for the determination of Se, Sb and Sn with atomic absorption spectrometry

Evaluation of a Hydride Generation-Atomic Fluorescence System for the Determination of Arsenic Using a Dielectric Barrier Discharge Atomizer

Simultaneous determination of arsenic and antimony by hydride generation atomic fluorescence spectrometry with dielectric barrier discharge atomizer

Atomization of Hydride with A Low-Temperature, Atmospheric Pressure Dielectric Barrier Discharge and Its Application to Arsenic Speciation with Atomic Absorption Spectrometry

Low Temperature Hydrogen Plasma Assisted Chemical Vapor Generation for Atomic Fluorescence Spectrometry

Determination of Bismuth in Solid Samples by Hydride Generation Atomic Fluorescence Spectrometry with a Dielectric Barrier Discharge Atomizer

Developments In Accelerator Mass Spectrometry (Ams) Method For Hf-182

Next generation of dielectric barrier discharge hydride atomizers for atomic absorption spectrometry: A case study on Pb, Bi, Se and Te

Determination Of Ultra-Trace Amounts Of Selenium In Environmental Samples By Sequential Injection-Hydride Generation-Nondispersive Atomic Fluorescence Spectrometry

Evaluation of Tungsten Coil Electrothermal Vaporization-Ar/h2 Flame Atomic Fluorescence Spectrometry for Determination of Eight Traditional Hydride-Forming Elements and Cadmium Without Chemical Vapor Generation.

Determination of antimony in water samples by hydride generation coupled with atmospheric pressure glow discharge atomic emission spectrometry

A novel atmospheric pressure glow discharge system for sensitive determination of As, Sb, and Se by optical emission spectrometry following their hydride generation

Dielectric Barrier Discharge Atomizer for Mercury Speciation by HPLC-CVG Atomic Fluorescence Spectrometry

Flow Injection–electrochemical Hydride Generation Technique for Atomic Absorption Spectrometry. Invited Lecture

Evaluation of continuous hydride generation combined with helium and argon microwave induced plasmas using a surfatron for atomic emission spectrometric determination of arsenic, antimony and selenium

Atomic Absorption Determination of Lead, Bismuth, Selenium, Tellurium, Thallium and Tin in Complex Alloys Using Direct Atomization from Metal Chips in the Graphite Furnace

Determination of Germanium, Arsenic, Tin, Selenium, and Antimony by Plasma Emission Spectrometry with Hydride Generation and Chromatographic Separation

Determination of Metals in Environmental Waters by Solution Cathode Glow Discharge -Atomic Emission Spectroscopy (SCGD-AES) with a Syringe Pump for Sample Introduction

Contribution of System Components to Dispersion in the Analysis of Microvolume Samples by Flow-Injection Flame Atomic-Absorption Spectrometry

Diffusion flame, heated quartz tube or dielectric barrier discharge? Comparing the resistance of hydride atomizers towards interferences with detection by atomic absorption spectrometry