Abstract:In this study, cooling of a plastic pipe-end during a hot-forming process that is one of the commonly used forming methods in plastic pipe production to get seal housing place (muff) was investigated numerically and experimentally. The aim of this study was development of a cooling die that has higher cooling performance and easier manufacturability. Cooling is supplied by the circulation of conditioned water in the channels located in the die in plastic production. The geometry of these channels and mass flow rate and temperature of the cooling water are the parameters affecting the quality of the formed region and process time. In the study, experimental analyses were performed, then numerical analyses were realised and validated with the experimental results for the existing die geometry. Continuity, momentum and energy equations were solved all together and heat transfer was investigated. After validating the model, a few different alternative die models were proposed and analysed to get an optimum which has highest cooling capacity and process ability. At the end of these studies, optimum alternative die geometry was determined. The channels in the suggested die were developed to increase the homogeneity of the cooling by changing the existing channel’s shape which can be produced by only longitudinal holes. A simple production method was also suggested for the new die to locate the channels following the circumference of the pipe, like conformal cooling channels. Additionally, aluminium material was also used to decrease the pipe temperature and die weight in the analyses. In conclusion, although cooling process time and mean temperature of the pipe-end were 30 secs and 43.9 o C respectively for the existing cooling die, these values were determined as 30 secs and 39.5 o C for the optimised aluminium die. If the temperature of the cooled pipe is taken as the same with the existing cooling, the cooling time decreases to around 20 secs for the suggested die. The weight of the die was reduced from 86.57 kg to 16.22 kg.

Cooling and annealing of plastic pipe

The Study of Controlled Cooling Technology and Warping of X65 Heavy Pipeline Plate

Calculation and comparison between alternate and continuous controlled cooling technology for X65 pipeline steel plate

Thermo-Mechanical Coupling Computation and Warping Analysis During Controlled-Cooling of X65 Heavy Pipeline-Plate

DEVELOPMENT OF A COOLING DIE USED IN PLASTIC PIPE PROCESSING: NUMERICAL AND EXPERIMENTAL ANALYSIS

Viscoelastic and Damage Model of Polyethylene Pipe Material for Slow Crack Growth Analysis

Latent heat and TRIP effect of X65 heavy pipeline plate during controlled cooling

Synergistic Effects of Α/β-Nucleating Agents on Propylene-Ethylene Random Copolymer: New Clues for the Pipe Extrusion

The effect of high-temperature annealing on thermal properties and morphology of polyethylene pipes prepared by rotational shear

Applicability Analysis of Thermoplastic Material As Liner Pipe for Trenchless Rehabilitation of Thermal Pipelines

Development of High-Density-Polyethylene-Based Thick Multi-Reducer Injection Mold Incorporating Cooling Analysis Technology

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

A New Approach Of Piping Dynamic Response Considering Plastic Effect

Creep rapture of plastic pipes: Effect of eccentricity, residual stress, and circumferential orientation

Production of Pipe with Uniform Wall Thickness: How to Compensate for Gravity Sag

Long-Term Stress Analysis of Plastic Pipe Reinforced by Cross-Winding Steel Wire

Role of Melt Plasticizing Temperature in Morphology and Properties of PE100 Pipes Prepared by a Rotational Shear System

The Influences of Cooling Rate on Shrink and Shrinkage Formation of HDPE Thick Parts

Stress Analysis of Plastic Pipe Reinforced by Cross Helically Wound Steel Wires

The effect of annealing time on morphology, mechanical properties, and thermal conductivity of HDPE pipes produced by rotational shear