Abstract:In offshore renewable energy design procedures, accurate predictions of extreme responses are required in order to design for survivability whilst minimising associated costs. At present, the established method for predicting extreme responses is to conduct a large number of long-duration simulations, which is practical only in cases where the structural behaviour is captured by a computationally efficient linear approach. Many applications, however, will require a nonlinear approach, which significantly increases the computational cost, and hence the time required to analyse a problem. Should high-fidelity numerical approaches be the appropriate analysis tool, the long-duration simulations are likely to be impractical and in many cases infeasible. Laboratory testing can be utilised to address this to some extent, but this still time-consuming and expensive from a financial perspective. Consequently, there has been considerable interest in the use of short design waves as an alternative method for speeding up the design process. Currently, standards advise that short design waves can be utilised in the design of fixed offshore structures, but application to floating offshore structures needs verification before it becomes an established procedure. This study considers application of single and constrained short design waves to a floating hinged-raft wave energy converter using a 1:50 scale physical modelling approach, and compares with equivalent irregular sea states. The single wave approaches considered here are "NewWave" and the "Most Likely Extreme Response" wave, which are derived from the frequency content of the wave spectrum and response spectrum, respectively. The constrained approach considered in this study is the "Conditional Random Response Wave," where the Most Likely Extreme Response wave is embedded within a random short irregular background. Results show that the single wave approaches under-estimate the extreme loading for the hinge-angle and mooring system compared with the irregular and constrained approaches. The discrepancy between single and constrained waves implies that memory effects are non-negligible, and hence it is critical that they are accounted for when utilising short design waves for floating applications.

OpenFOAM design sensitivity analysis on a homogeneous low-crested structure with concrete elements seaward of a vertical seawall to reduce overtopping

Numerical Investigations of Pedestrian Overboard on a Compound Slope Dike Due to Excessive Overtopping Waves

A CIP-based Numerical Simulation of Wave Interaction with a Fluid-Filled Membrane Submerged Breakwater

Oscillatory Responses of a Spatially Random Seabed in the Vicinity of Structures: Validation and Application of the Integrated CFD-SFEM

Computational Study of Overtopping Phenomenon over Cylindrical Structures Including Mitigation Structures

Wave overtopping discharges at rubble mound structures in shallow water

Experimental and numerical analysis of the geometry of a laboratory-scale overtopping wave energy converter using constructal design

Wave Overtopping Control Effect of AWOC Equipped With Self-Adaptive Floating Concrete Structure: A Numerical Study

Parametric Analysis Of Wave-Induced Forces And Overtopping On Composite Vertical Breakwaters With Retreated Crown Wall

Numerical modelling of the spatial distribution of wave overtopping water behind dikes under regular wave action using OpenFOAM

Laboratory investigation on short design wave extreme responses for floating hinged-raft wave energy converters

Optimal Design of the Overtopping Wave Energy Converter Based on Fluid–Structure Interaction Simulation

Numerical Evaluation of Wave Dissipation on a Breakwater Slope Covered by Precast Blocks with Different Geometrical Characteristics

Benchmarking of Numerical Models for Wave Overtopping at Dikes with Shallow Mildly Sloping Foreshores: Accuracy versus Speed

A Multiscale Material-Structure-hydroelasticity Coupled Analytical Model for Floating Sandwich Structures with Hierarchical Cores

Numerical Simulation of an Oscillating Water Column Device Installed over a Submerged Breakwater

Physical Modelling Of The Wave Field Around An Array Of Centrally Controlled Wave Energy Converters

Numerical simulation of wave overtopping above perforated caisson breakwaters

Impact of sloping porous seabed on the efficiency of an OWC against oblique waves

CFD Modelling to Investigate Design of a Whaleback-Type Forecastle for Greenwater Protection

Experimental Study of Wave Overtopping Flow Behavior on Composite Breakwater