Abstract:In offshore renewable energy design procedures, accurate predictions of extreme responses are required in order to design for survivability whilst minimising associated costs. At present, the established method for predicting extreme responses is to conduct a large number of long-duration simulations, which is practical only in cases where the structural behaviour is captured by a computationally efficient linear approach. Many applications, however, will require a nonlinear approach, which significantly increases the computational cost, and hence the time required to analyse a problem. Should high-fidelity numerical approaches be the appropriate analysis tool, the long-duration simulations are likely to be impractical and in many cases infeasible. Laboratory testing can be utilised to address this to some extent, but this still time-consuming and expensive from a financial perspective. Consequently, there has been considerable interest in the use of short design waves as an alternative method for speeding up the design process. Currently, standards advise that short design waves can be utilised in the design of fixed offshore structures, but application to floating offshore structures needs verification before it becomes an established procedure. This study considers application of single and constrained short design waves to a floating hinged-raft wave energy converter using a 1:50 scale physical modelling approach, and compares with equivalent irregular sea states. The single wave approaches considered here are "NewWave" and the "Most Likely Extreme Response" wave, which are derived from the frequency content of the wave spectrum and response spectrum, respectively. The constrained approach considered in this study is the "Conditional Random Response Wave," where the Most Likely Extreme Response wave is embedded within a random short irregular background. Results show that the single wave approaches under-estimate the extreme loading for the hinge-angle and mooring system compared with the irregular and constrained approaches. The discrepancy between single and constrained waves implies that memory effects are non-negligible, and hence it is critical that they are accounted for when utilising short design waves for floating applications.

Experimental and numerical analysis of the geometry of a laboratory-scale overtopping wave energy converter using constructal design

Scaling Orchestration in Physical Model Test of Oscillating Buoy Wave Energy Converter

Theoretical and Numerical Studies of Off-Shore Oscillating Water Column Wave Energy Device

Study of the Geometry of an Oscillating Water Column Device with Five Chambers Coupled under Regular Waves through the Constructal Design Method

Optimal Design of the Overtopping Wave Energy Converter Based on Fluid–Structure Interaction Simulation

Geometric Evaluation of an Oscillating Water Column Wave Energy Converter Device Using Representative Regular Waves of the Sea State Found in Tramandaí, Brazil

Computational Study of Overtopping Phenomenon over Cylindrical Structures Including Mitigation Structures

Geometric Evaluation of the Hydro-Pneumatic Chamber of an Oscillating Water Column Wave Energy Converter Employing an Axisymmetric Computational Model Submitted to a Realistic Sea State Data

Laboratory investigation on short design wave extreme responses for floating hinged-raft wave energy converters

Numerical and Experimental Power Output Estimation for a Small-Scale Hinged Wave Energy Converter

Towards standardised design of wave energy converters: A high-fidelity modelling approach

Experimental Results from Wave Tank Trials of a Multi-Axis Wave Energy Converter

Control co-design and optimization of oscillating-surge wave energy converter

OpenFOAM design sensitivity analysis on a homogeneous low-crested structure with concrete elements seaward of a vertical seawall to reduce overtopping

Parametric Analysis Of Wave-Induced Forces And Overtopping On Composite Vertical Breakwaters With Retreated Crown Wall

Physical Modelling Of The Wave Field Around An Array Of Centrally Controlled Wave Energy Converters

Modeling and optimization for arrays of water turbine OWC devices

Modelling and simulation of a wave energy converter

Experimental study of an onshore dual chamber oscillating water column device

Finite Element Modeling and Simulation of a Submerged Wave Energy Converter System for Application to Oceanic Islands in Tropical Atlantic

Numerical modeling of wave basin experiments of a floating wind turbine with active thrust emulation: A discussion of important aspects