Abstract:Composite vertical breakwaters are monolithic structures often used to protect port basins, especially in deep-water conditions. At present, the design of these structures is mainly based on Goda's formulae (Goda, 2010) or on the probabilistic design tools (PROVERBS) proposed by Oumeraci et al. (2001), while their hydraulic performance in terms of overtopping can be predicted by using the tools described in the EurOtop Manual (EurOtop Manual, 2018). Due to the size of these structures, the optimization and the improvement of the hydraulic performances (e.g. reduction of wave loads, wave overtopping, etc.) of these breakwaters can lead to significant economic saving. Typically, designers try to make small geometric changes without modifying the main geometrical dimensions of these structures. One of these technical solutions consists in placing the cast-in-situ concrete crown wall at a retreated position with respect to the front caisson face. It is assumed that the retreat of the crown wall, for geometric reasons, induces a time lag between the loads acting on the lower front external seawall face and on the crown wall of the caisson; furthermore, this could introduce a change in the pulsating nature of the loads, introducing also turbulent dissipations, consequently reducing the reflection coefficient and modifying the wave overtopping. To the best authors’ knowledge, in the literature there is a lack of guidelines to consider the effects of crown wall retreat in terms of wave actions and hydraulic performance of the structure. Recently, Romano & Bellotti (2023), based on physical model tests, provided a first experimental insight on the increase/reduction of the wave loads acting on deep water vertical breakwaters with retreated crown wall.

Wave Overtopping Control Effect of AWOC Equipped With Self-Adaptive Floating Concrete Structure: A Numerical Study

Numerical Investigations of Pedestrian Overboard on a Compound Slope Dike Due to Excessive Overtopping Waves

Numerical and Experimental Study on A 2-D Floating Body under Extreme Wave Conditions

Hydrodynamic Performance of a T-shaped Floating Breakwater

Optimal Design of the Overtopping Wave Energy Converter Based on Fluid–Structure Interaction Simulation

Experimental Study of Wave Overtopping Flow Behavior on Composite Breakwater

Experimental and numerical investigation of WEC-type floating breakwaters: A single-pontoon oscillating buoy and a dual-pontoon oscillating water column

Numerical Simulation of an Oscillating Water Column Device Installed over a Submerged Breakwater

Numerical Study of Rogue Wave Overtopping with a Fully-Coupled Fluid-Structure Interaction Model

Hydrodynamic Performance of an Asymmetry OWC Device Mounted on a Box-Type Breakwater

Wave dissipation effect of a new combined breakwater and its protective performance for coastal box girder bridges

Hydrodynamic Performance of a Pile-Supported OWC Breakwater: an Analytical Study

Experimental and Numerical Analysis of Power Take-off Control Effects on the Dynamic Performance of a Floating Wind-Wave Combined System

Numerical modelling of the spatial distribution of wave overtopping water behind dikes under regular wave action using OpenFOAM

Numerical Study on Wave Dissipation Performance of OWC-Perforated Floating Breakwater under Irregular Waves

Geometry of OWC and Rectangular Submerged Breakwater

Parametric Analysis Of Wave-Induced Forces And Overtopping On Composite Vertical Breakwaters With Retreated Crown Wall

A Symmetric Experimental Study of the Interaction Between Regular Waves and a Pontoon Breakwater with Novel Fin Attachments

Wave power extraction by an oscillating water column array embedded in comb-type breakwaters: Performance analysis and hydrodynamic mechanism

Experimental investigation on the hydrodynamic performance of a pile-supported OWC-type breakwater

Effects of submerged dike on overtopping against seawall of composite profile in regular waves