Abstract:New time-based readout (TBR) electronics has been developed and evaluated for its performance and application for PET detectors. It consists of a leading edge (LE) timing threshold for timing pickoff that provides a signal timing t1; a charge integration followed by a constant discharge between two specific timings t2 and t3 that are used to directly measure the signal energy. The timing-walk error caused by LE from signals of different amplitudes can be measured with t1 as a function of different signal amplitudes that is proportional to the time difference between t2 and t3. With this pre-calibration, timing-walk error can be accurately corrected. Therefore, both signal timing and energy can be accurately measured with digital timing signals without using CFD and ADC. These timing signals were controlled and in principle can be measured by an FPGA that can apply many signal logic and data correction algorithms. A single channel discrete component TBR circuit has been implemented in PC board, and 8-channel ASIC chips have been developed for feasibility evaluations and PET detector applications. Initial functionality and performance evaluations have been conducted. Signal amplitude measurement accuracy and linearity are very good; the measured timing accuracy from a pulse is the same as a standard CFD and reaches to similar to 100 ps resolution with the test setup. Both suitable energy and coincidence timing resolutions (similar to 17% and similar to 1.0-2.0 ns) were achieved with PMT or Solid-State PM (SSPM) array based PET detectors. Initial studies to acquire flood source crystal identification map has demonstrated the advantages of applying parallel readout with TBR electronics that read out and process signals from each pixel of SSPM array independently. With its relatively simple circuit and low cost, TBR electronics is expected to provide suitable front-end signal readout electronics for compact photon detectors such as SSPM array that require large number of output channels and demand high performance in energy and timing.

A novel method based solely on FPGA units enabling measurement of time and charge of analog signals in Positron Emission Tomography

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Evaluation of Single-Chip, Real-Time Tomographic Data Processing on FPGA - SoC Devices

Dual threshold input receiver FPGA-only signal digitization method for time-of-flight positron emission tomography

The design of a time-interleaved analog-digital conversion modulator based on FPGA-TDC for PET application

A compact and highly integrated 128-channel FPGA-based readout electronics for nuclear imaging application

Energy And Timing Measurement Of A Pet Detector With Time-Based Readout Electronics

Energy and Timing Measurement with Time-Based Detector Readout for PET Applications: Principle and Validation with Discrete Circuit Components.

A monolithic ASIC demonstrator for the Thin Time-of-Flight PET scanner

Positronium imaging with the novel multiphoton PET scanner

Front-End Electronics Design Based on Vernier Method for A High Resolution Micropet

FPGA-based digitizer for BGO-based time-of-flight PET

A Simple Smart Time-to-digital Convertor Based on Vernier Method for a High Resolution LYSO MicroPET

Contribution of high energy physics techniques to the medical imaging field

Real-Time FPGA-based Digital Signal Processing and Correction for a Small Animal PET

An FPGA Based Fast Linear Discharge Method for Nuclear Pulse Digitization

Characterization of TOF-PET Detectors Based on Monolithic Blocks and ASIC-Readout

Feasibility study of the positronium imaging with the J-PET tomograph

An FPGA Based energy correction method for one-to-one coupled PET detector: model and evaluation

Design and evaluation of a FPGA-ADC prototype for the PET detector based on LYSO Crystals and SiPM arrays

First experimental time-of-flight-based proton radiography using low gain avalanche diodes