Abstract:Bed joint reinforced repointing is a retrofitting technique for unreinforced masonry structures that is commonly applied in the Netherlands to repair settlement-induced damage. Using this technique, the bed joints of masonry walls are reinforced with steel rebars that are embedded in a high strength repair mortar. Due to the increase of induced seismic events in the northern part of the Netherlands, an experimental study was carried out at Delft University of Technology to investigate the performance of this retrofitting technique for combined settlement and seismic loading. This paper aims to simulate the experimental results, with a focus on the comparison of different finite element modelling approaches for studying both un-strengthened and strengthened full-scale tested walls. To that end, three different models are investigated – comprising both macro (continuum) and simplified and detailed micro (brick-to-brick) modelling approaches. The bricks and mortar joints are modelled as one homogenous continuum in the macro model, whereas in the two brick-to-brick models these structural components are modelled separately, with the detailed model including interface elements to simulate the brick–mortar bonds. Nonlinear pushover analyses are subsequently carried out using all three modelling approaches, for both monotonic and cyclic loading cases. Based on these analyses, the detailed brick-to-brick model was found unsuitable to simulate the strengthened wall because cracks in the model mainly occur in the form of opening of the brick–mortar bond interfaces, while smeared cracking in the plane stress elements of the mortar joints is very limited. Similarly, the continuum damage model was found to be inaccurate when pre-existing damage in the experiment needed to be taken into account. The continuum damage model also showed lower axial stresses in the rebars, compared with the simplified brick-to-brick model, as the former does not allow for the direct assignment of material properties for the high strength repair mortar in the strengthened joints.

Comsol Simulations of Cracking in Point Loaded Masonry with Randomly Distributed Material Properties

Stochastic Fracture of Concrete Composites: A Mesoscale Methodology

Simulation Of Collapse Process Of Masonry Walls Based On Expanded Discrete Element Method

Monte Carlo simulation of complex cohesive fracture in random heterogeneous quasi-brittle materials

Monte Carlo Simulation of Complex 2D Cohesive Fracture in Random Heterogeneous Quasi-Brittle Materials

Simulation and Experimental Verification of the Non-Uniform Corrosion Cracking Process of Reinforced Mortar Specimen

Monte Carlo Simulation of Complex Cohesive Fracture in Random Heterogeneous Quasi-Brittle Materials: A 3D Study

Tensile Fracture Mechanism of Masonry Wallettes Parallel to Bed Joints: A Stochastic Discontinuum Analysis

Progress in Complex 2d and 3d Cohesive Fracture Modelling Considering Random Heterogeneity

Numerical Simulation of Fracture and Damage Behaviour of Concrete at Different Ages

Simulation and analysis of infilled-wall cracks' development by shrinkage using semi-discrete and whole type model

Two-Dimensional Meso-Scale Simulation of Hydraulic Fracture in Concrete

Simulation of Masonry Wall using Concrete Damage Plasticity Model

3D Finite Element Simulation of Complex Static and Dynamic Fracture in Quasi-Brittle Materials

Analytical modeling of masonry load-bearing walls

Mesoscopic modeling and simulation of tensile properties of cracked concrete using cohesive model

Combined Finite-Discrete Element Model Simulations of Shake-Table Tests on a Full-Scale Masonry Cross Vault

Two-dimensional X-ray CT Image Based Meso-Scale Fracture Modelling of Concrete

Monte Carlo Simulations of Mesoscale Fracture Modelling of Concrete with Random Aggregates and Pores

Comparative numerical study to simulate masonry with bed joint reinforced repointing

Study on the internal crack network of the ASR-affected concrete by the tomography-based numerical model