Abstract:Recent progress on high efficiency Tm-doped silica fibers pumped at 790nm has enabled the demonstration of a 2 mu m CW fiber laser operating at the 1kW power level and with single mode beam quality [1]. In addition to this state-of-the-art high power research, Tm-doped fibers are now starting to find applications in lasers with nsec [2] and psec [3] pulsed operation, as well as lower power CW lasers (50-100W) in the 1940nm wavelength region for medical use [4].As with Yb-doped fibers, the question of photodarkening needs to be addressed to ensure the long term fiber reliability is appropriate for the application. In a recent paper [5], we proposed that the up-conversion process in highly doped Tm-fibers was significantly quenched when compared with lower concentration fibers, under 790nm pumping. This trend was also observed in the photodarkening rate as measured in a CW 2 mu m fiber laser cavity operating around 20W output power. In this controlled experiment, the rate of photodarkening dropped from 15% per 1000 hours in low concentration fiber to less than 1% in a fiber doped with 4.6% Tm.In this paper we review the 20W results of our earlier work and then confirm the long term reliability of 1940nm CW fiber lasers operating at higher (40W) output power, presenting results for a laser operating for 1200 hours without significant loss of output power (around 12% total power variation). Over any given 24-hour period during this experiment, the laser operates open loop with around 8% total power variation, in an air cooled configuration. We believe these results confirm the appropriate level of long term reliability of Tm-doped fibers for CW fiber lasers at the similar to 50W power level, suitable for medical laser applications.

Revisiting literature observations on photodarkening in Yb3+doped fiber considering the possible presence of Tm impurities

Direct Observation of Multimode Interference in Rare-Earth Doped Micro/nanofibers

Comment on "Observation of dark pulse in a dispersion-managed fiber ring laser"

Elimination of the Photodarkening Effect in an Yb-Doped Fiber Laser with Deuterium

Mitigation of Photodarkening Effect in Yb-doped Fiber Through Na+ Ions Doping.

Influence of Pre-Radiation and Photo-Bleaching on the Yb-Doped Fiber Laser Radiated with Gamma-ray

Deep UV-induced near-infrared photodarkening of Er/Yb-doped and undoped phosphate fibers

Reliability and Photodarkening in 790Nm-Pumped 2μm Fiber Lasers

Photoluminescence and energy transfer mechanisms of Tm3+ doped Y2O3 laser crystals: Experimental and theoretical insights

An Investigation of the Optical Properties of Tb3+-doped Phosphate Glasses for Green Fiber Laser

The theoretical calculation and output characteristic analysis of Yb doped fiber laser

Photodarkening Effect Suppression in Yb-doped Fiber Through the Nanoporous Glass Phase-Separation Fabrication Method

Radiation Effects on Ytterbium- and Ytterbium/Erbium-Doped Double-Clad Optical Fibers

Effects of fabrication methods on spin relaxation and crystallite quality in Tm-doped Y$_2$Al$_5$O$_{12}$ powders studied using spectral hole burning

Mode instability thresholds for Tm-doped fiber amplifiers pumped at 790 nm

Study of photodarkening mechanism of Tb3+-activated silica, phosphate, fluorophosphate, and fluoride glasses

Visible and near infra-red up-conversion in Tm3+/Yb3+ co-doped silica fibres under 980 nm excitation

Impact of gamma-ray radiation-induced photodarkening on mode instability degradation of an ytterbium-doped fiber amplifier

Impact of thermal lensing on the TMI threshold powers in rod-type Yb-doped fiber amplifiers

Effects of Yb3+ Concentration on Up-Conversion Luminescence and Temperature Sensing Characteristics of Tm3+/Yb3+:Y2O3 Phosphors

Tm-Doped Fiber Lasers: Fundamentals and Power Scaling