Abstract:The pressure of electromagnetic radiation in the optical range is widely used to hold microparticles in a given place and control their movement. This is possible by focusing the laser radiation into an area with the dimension of several micrometers. The intensity of radiation in this area is large and sufficient to retain micro-particles in the laser beam and manipulate them. Nowadays, intensive research is underway on the use of microwave and terahertz radiation and the possibility of applying radiation pressure in these ranges. But in the microwave range, the focal spot dimension is much larger than in the optical one. Therefore, control of the objects whose dimensions are comparable to those of the focal spot using the radiation pressure requires very high power. For the objects with small dimensions, a small amount of radiation energy falls on them, and the acting force decreases. However, it is known that thin conductive fibers interact very strongly with microwave radiation. This can be used to levitate short thin metal fibers (vibrators), hold them in predicted place and control their position in space. The paper describes the measurements of the pressure of microwave radiation with a wavelength of 8 mm on thin copper fibers. Torsional balance is used for this purpose. In the metal case on a suspension from a tungsten fiber with a diameter of 8 microns there is located the rocker arm with 50 mm length with receiving elements in the form of system of copper fibers with a diameter of 300 microns and 15 mm length. Microwave radiation was directed to one of the receiving elements using a horn. The calibration of torsion balance, the measurement process, and the evaluation of the resulting error are described. The measurements gave the value of the efficiency factor of the radiation pressure Qpr = 4.86. This agrees satisfactorily with the results of calculations Qpr = 5.39. The difference is 10%.

Optical measurement of acoustic radiation pressure of the near-field acoustic levitation through transparent object

Theoretical and experimental examination of near-field acoustic levitation

Direct measurement of forces in air-based acoustic levitation systems

Pressure-sensitive paint measurements in a shock tube

Pressure-sensitive Paint with Imprinted Pattern for Full-Field Endoscopic Measurement Using a Color Camera

Study on Transient Properties of Levitated Object in Near-Field Acoustic Levitation

A Contactless Methodology of Picking Up Micro-Particles from Rigid Surfaces by Acoustic Radiation Force

Angular Measurement of Acoustic Reflection Coefficients by the Inversion of V(z, T) Data with High Frequency Time-Resolved Acoustic Microscopy

Time-resolved phase-lock pressure-sensitive paint measurement of trailing edge noise dynamics

Pressure-Sensitive Paint Measurements in Narrow Clearances: A Feasibility Study

Rapid rise of planar object by near-field acoustic levitation on recessed acoustic radiation surface

Calculation of Acoustic Field Based on Laser-Measured Vibration Velocities on Ultrasonic Transducer Surface

Three-dimensional imaging of acoustic pressure by tomography applied to optical feedback interferometry

Dynamic Mode Decomposition of Fast Pressure Sensitive Paint Data

Measurement of the acoustic radiation force on a sphere embedded in a soft solid

Acoustic Radiation Simulation and Pre-Stress Effect on Compact Acoustic Levitation Platform

Application of Optical Interferometry in Focused Acoustic Field Measurement

Non-intrusive planar velocity-based nearfield acoustic holography in moving fluid medium

Contactless Weighing Method based on Deep Learning and Acoustic Levitation

Transient Measurement of Near-field Thermal Radiation between Macroscopic Objects

Measurement of microwave radiation pressure on thin metal fibers