Concurrent Hardening and Toughening of a Tungsten Heavy Alloy via a Novel Carburizing Cyclic Heat Treatment

Ke Hu,Xiaoqiang Li,Bo Liu,Shengguan Qu,Liang Liang,Khashayar Khanlari

DOI: https://doi.org/10.1002/adem.202001283

IF: 3.6

2021-01-27

Advanced Engineering Materials

Abstract:<p>Tungsten heavy alloys (WHAs), due to the combination of some attractive properties, are used in many engineering applications. Recently conducted researches are though focused on improving the surface properties of these alloys, such as their hardness, wear and corrosion resistance, by applying different surface treatments. However, the obtained enhanced surface properties were concomitant with the maintenance or even deterioration of the mechanical properties, namely toughness, in the interior regions of these alloys. In this research, a novel carburizing‐cyclic heat treatment (CCHT) integrated technique was employed to modify the microstructure of a 93W‐4.9Ni‐2.1Fe heavy alloy (93WHA). Other than investigating the effect of the applied process on the surface hardness and microstructure of this alloy, the influence of the conducted process on the microstructural and mechanical properties of the interior region of the processed parts was investigated. Due to the application of the CCHT process, the surface hardness of parts increased from 300 HV_0.5, observed in the non‐treated samples, to the maximum value of 1049 HV_0.5. In addition to the hardening effect observed on the surface of the treated samples, the interior regions of the CCHT modified parts were toughened.</p><p>This article is protected by copyright. All rights reserved.</p>

materials science, multidisciplinary