Abstract:A multi-element graphite furnace atomic absorption spectrometry (GFAAS) method was elaborated and applied for the simultaneous determination of As, Cd, Cr, Cu, and Pb in various kinds of honey samples (acacia, floral, linden, rape, and milkweed) using the transversally heated graphite atomiser (THGA) with end-capped tubes and integrated graphite platforms (IGPs). For comparative GFAAS analysis, direct (without digestion) and indirect (with digestion in a microwave oven) sample preparation procedures were tested. The effects of several chemical modifiers, such as NH(4)H(2)PO(4), NH(4)H(2)PO(4)-Mg(NO(3))(2), and Pd(NO(3))(2)-Mg(NO(3))(2), were studied to obtain optimal pyrolysis and atomization conditions for the set of analytes studied. The most efficient modifier was proved to be the mixture of 5microg Pd (applied as nitrate) plus 3microg Mg(NO(3))(2), allowing the optimal 600 degrees C pyrolysis and 2300 degrees C atomization temperatures. To prevent the sputtering and foaming of the matrix during the drying and pyrolysis steps of the furnace heating program, the sample and modifier solutions (20+5microl, respectively) were dispensed together onto the IGP of the THGA pre-heated at 80 degrees C. The effect of increasing concentration of honey matrix was studied on the integrated absorbance (A(int)) signals of analytes. The A(int) signals of Cr and Pb were not altered up to 10% (m/v) matrix content in the sample solutions. The matrix effect was slightly suppressive on the A(int) signals of As, Cd, and Cu above 2% (m/v) honey concentration. The recovery was found to be ranged between 85 and 115% for Cd, Cr, Cu, and Pb, whereas it was a lower, compromise value of 70-99% for As. The limit of detection (LOD) data were 1, 0.04, 0.09, 0.3, and 0.6microg l(-1) for As, Cd, Cr, Cu, and Pb, respectively, which values correspond to 20, 0.8, 1.8, 5.3, and 12ng g(-1), respectively, in the solid samples. The characteristic masses were found to be 21 pg As, 1.3 pg Cd, 4 pg Cr, 12 pg Cu, and 33 pg Pb. The As, Cd, Cr, Cu, and Pb contents of the studied 42 honey samples varied significantly, i.e. from below the LOD up to 13, 3.3, 109, 445, and 163ng g(-1), respectively.

On-line preconcentration and determination of cadmium in honey using knotted reactor coupled to flow injection-flame atomic absorption spectrometry

Determination of cadmium in biological materials by flame atomic absorption spectrometry with flow-injection on-line sorption preconcentration

Simultaneous Determination of Cd(II) and Pb(II) Ions in Honey and Milk Samples Using a Single-Walled Carbon Nanohorns Modified Screen-Printed Electrochemical Sensor.

On-line separation and preconcentration of trace cadmium in environmental water samples by micro column filled with modified nanometer Si-HAP prior to FAAS determination

Determination of trace cobalt, nickel and cadmium by on-line flow injection analysis with coprecipitation preconcentration FAAS

Determination of Copper in Water and Rice Samples by Flame Atomic-Absorption Spectrometry with Flow-Injection Online Adsorption Preconcentration Using A Knotted Reactor

A new synthesis, characterization and application chelating resin for determination of some trace metals in honey samples by FAAS

A Sequential Injection On-Line Column Preconcentration System for Determination of Cadmium by Electrothermal Atomic Absorption Spectrometry

Use of Nb(2)O(5)-SiO(2) in an automated on-line preconcentration system for determination of copper and cadmium by FAAS

Flow Injection On-Line Coprecipitation Preconcentration for Electrothermal Atomic Absorption Spectrometry

Determination of Cadmium, Lead and Copper in Water Samples by Flame Atomic-Absorption Spectrometry with Preconcentration by Flow-Injection On-Line Sorbent Extraction.

Determination of trace copper and nickel in environmental and biological samples by flow injection on-line microcolumn preconcentration flame AAS using acrylic acid-grafted polytetrafluoroethylene fiber for column packing

Acrylic acid grafted polytetrafluoroethylene fiber as new packing for flow injection on-line microcolumn preconcentration coupled with flame atomic absorption spectrometry for determination of lead and cadmium in environmental and biological samples

Interference-free determination of trace copper in freshly ripened honeys by flame atomic absorption spectrometry following a preconcentration by solid-phase extraction and a two-step elution process

On-line Micro-Packed Column Solid-Phase Extraction of Cadmium Using Metal-Organic Framework (MOF) UiO-66 with Posterior Determination by TS-FF-AAS

Study on the simultaneous determination of some essential and toxic trace elements in honey by multi-element graphite furnace atomic absorption spectrometry

Effective and High-Throughput Analytical Methodology for the Determination of Lead and Cadmium in Water Samples by Disposable Pipette Extraction Coupled with High-Resolution Continuum Source Graphite Furnace Atomic Absorption Spectrometry (HR-CS GF AAS)

An Efficient Flow-Injection System with On-Line Ion-Exchange Preconcentration for the Determination of Trace Amounts of Heavy Metals by Atomic Absorption Spectrometry

Determination of Ni, Cu and Hg by flow injection preconcentration coupled with HPLC

Determination of traces of copper and zinc in honeys by the solid phase extraction pre-concentration followed by the flame atomic absorption spectrometry detection

Online Flow-Injection Cobalt-Ammonium Pyrrolidin-1-Yldithioformate Coprecipitation for Preconcentration of Trace Amounts of Metals in Waters with Simultaneous Determination by Inductively-Coupled Plasma-Atomic Emission-Spectrometry