Abstract:Chemical looping reforming (CLR) with biomass pyrolysis oil (BPO) for syngas production was investigated using NiO/dolomite as the bed material which was prepared by the wet impregnation method. The NiO/dolomite was used as catalyst and oxygen carrier in the whole temperature range, while it was also acted as in-situ CO2 sorbent at 600 °C and 700 °C. The syngas production was dominated by the sorption enhanced and catalytic reforming of BPO, due to the formation of NiO–MgO solid solution, which had a lower reducibility at low temperatures. Although, the low level CGE at low temperature could be improved by elevating the oxygen coefficient at the certain extent, poor cyclic performance of NiO/dolomite at 700 °C was observed, owning to the sintering and agglomeration during the repeated carbonation/calcination reactions. High temperatures inhibited the carbonation reaction and facilitated the reduction of NiO–MgO solid solution to provide more lattice oxygen and catalytic active sites. The syngas production was governed by the synergistic effect of lattice oxygen and catalysis at high temperatures. The optimum operating condition for syngas production in CLR was obtained by the analysis showed as follows: the temperature at 900 °C with ϕ = 0.4 in fuel reactor. The corresponding values of cold gas efficiency (CGE), syngas yield (Ysyn) and syngas purity (Psyn) were 80.76%, 1.318 Nm3/kg and 92.06%, respectively. Besides that, the NiO/dolomite exhibited a good cycle performance under this condition. The CGE and Ysyn decreased slightly to 76.26% and 1.265 Nm3/kg after 10 cycles, respectively. Overall, NiO/dolomite is a promising multifunctional material in the CLR process with BPO for syngas production. More attention should be paid to improve the mechanical strength of NiO/dolomite in the future.

Performance evaluation of carbon-negative syngas production via chemical looping reforming of methane from biomass pyrolysis volatiles

Chemical looping reforming of the micromolecular component from biomass pyrolysis via Fe2O3@SBA-16

Highly efficient and durable syngas production over one-step synthesized synergistic oxygen carriers in biomass chemical looping gasification

High-purity hydrogen production from real biomass pyrolysis vapors via a chemical looping process

Syngas production via chemical looping reforming using methane-based feed and NiO/Al2O3 oxygen carrier

Chemical looping pyrolysis-gasification of biomass for high H2/CO syngas production

Carbon‐negative syngas production: A comprehensive assessment of biomass pyrolysis coupling chemical looping reforming

Syngas production via chemical looping reforming biomass pyrolysis oil using NiO/dolomite as oxygen carrier, catalyst or sorbent

Chemical looping reforming of biomass based pyrolysis gas coupling with chemical looping hydrogen by using Fe/Ni/Al oxygen carriers derived from LDH precursors

New Process Combining Fe-Based Chemical Looping and Biomass Pyrolysis for Cogeneration of Hydrogen, Biochar, Bio-Oil and Electricity with In-Suit CO2 Separation

A novel system of biomass for the generation of inherently separated syngas by combining chemical looping CO2-gasification and steam reforming process

Hydrogen-rich syngas production from chemical looping gasification of lignite by using NiFe2O4 and CuFe2O4 as oxygen carriers

Syngas Production by Fe2SiO4 Oxygen Carrier in Chemical Looping Partial Oxidation of Methane

A Novel Ni–MoCxOy Interfacial Catalyst for Syngas Production Via the Chemical Looping Dry Reforming of Methane

Co-production of syngas and H2 from chemical looping steam reforming of methane over anti-coking CeO2/La0.9Sr0.1Fe1−xNixO3 composite oxides

Sorption-enhanced chemical looping steam reforming of glycerol with CO 2 in-situ capture and utilization

Chemical‐Looping Conversion of Methane: A Review

Energy-efficient Biogas Reforming Process to Produce Syngas: the Enhanced Methane Conversion by O2

Chemical looping combustion of biomass-derived syngas using ceria-supported oxygen carriers

Hybrid-functional Material for Sorption-Enhanced Hydrogen-Rich Syngas Production from Biomass: Effect of Material Preparation Process