Abstract:A large number of gas drainage pipes are obsoleted in the coal mine gas drainage system, and it causes serious waste. If concrete is poured into the discarded gas drainage pipes as components for underground roadway support, it is very significant for sustainable development of mine. Therefore, it is necessary to study the mechanical properties of the concrete-filled gas drainage steel pipe. Most frequently used gas drainage pipes are spiral welded steel pipe (SSP-I) and spiral external rib steel pipe (SSP-II). In this study, three different concrete-filled steel pipes are taken as the research object: SSP-I concrete-filled steel pipes, SSP-II concrete-filled steel pipes, and RSP concrete-filled ordinary round steel pipes. Through the axial compression test, the failure mode and relationship between stress-strain of concrete-filled steel pipes were obtained. Subsequently, the ultimate bearing capacity of three types of specimens was calculated based on the unified strength theory, limit equilibrium theory, and superposition theory. The test results show that both the SSP-I concrete-filled pipe columns and RSP concrete-filled pipe have good post-peak load-bearing capacity and ductility, and the second peak load reaches 70.38% and 81.92% of the ultimate load, respectively. The load-bearing capacity of SSP-II concrete-filled pipe columns is dropped sharply after bearing ultimate load, and the second peak load reaches only 36.47% of the ultimate load. The failure characteristics of concrete-filled gas drainage pipe columns show that the core concrete is compressed to powder and explain that the gas drainage pipe has fully exerted its restraint on the concrete. The FE method was used to simulate the compression test of three types of concrete-filled steel pipes, and the numerical simulation results show good agreement with the experimental results. Theoretical calculations show that the calculation of concrete-filled gas drainage pipe columns based on the superposition theory EC4-2004 is the closest to the measured value. Therefore, the EC4-2004 standard is recommended to calculate the ultimate bearing capacity of concrete-filled gas drainage pipe columns.

Review of Research Progress on Bearing Capacity of Steel Pipe Joints

Experimental study and capacity analysis of double-tapered rectangular steel tubes

Load-carrying capacity of welded hollow spherical joints subject to combined planar tri-directional axial force and bending moment

Experimental and numerical study on compressive behavior of welded hollow spherical joints with external stiffeners

Load-carrying Capacity and Practical Calculation Method of Welded Hollow Spherical Joints with Square Steel Tubes Subjected to Combined Axial Forces and Biaxial Bending Moments

Load-carrying Capacity and Practical Calculation Method of Welded Hollow Spherical Joints Connected with Square Steel Tubes

Experimental Investigation of Circular Steel Tubes with Tapered Ends Subjected to Bending,compression and Torsion

Nonlinear Analysis on Ultimate Flexural Bearing Capacity of the N-Shaped Steel Tubular Joints

Analysis of Ultimate Bearing Capacity and Parameters of Steel Support Cutting Pipe Roofing Structure

Experimental investigation and simulation analysis of cast-steel joints under vertical pressure

Site-based Experimental Study on Pipe Behavior During Pipe Jacking

Numerical analysis on bearing capacity about the outer sleeve K-joint of rectangular pipe truss

Finite Element Analysis of the Pipe-through Welded Ball Joints

Theoretical and Experimental Study on Load-Carrying Capacity of Combined Members Consisted of Inner and Sleeved Tubes

Effect of Stiffeners on the Bearing Capacity of Steel Support Cutting Pipe Structure

A numerical analysis on bending capacity of steel pipe columns using a mechanical joint with concrete-filled steel tube

Experimental study on the compression mechanical behaviour of steel pipes with mechanically induced pitting corrosion

A Study on Axial Compression Performance of Large Diameter-Thickness Ratio Concrete-Filled Gas Drainage Steel Pipe

The research on the critical loading path of thick-walled pipes under external pressure and cyclic bending

Axial Bearing Capacity of Composite-Sectioned Square Concrete-Filled Steel Tubes