Abstract:Considering the abundance of iron and manganese within the Earth's crust, the cathode O3-NaFe0.5Mn0.5O2 has shown great potential for large-scale energy storage. Following the strategy of introducing specific heteroelements to optimize the structural stability for energy storage, the work has obtained an O3-type NaFe0.4Mn0.49Cu0.1Zr0.01O2 that exhibits enhanced electrochemical performance and air stability. It displays an initial reversible capacity of 147.5 mAh g–1 at 0.1C between 2 and 4.1 V, a capacity retention ratio exceeding 69.6% after 100 cycles at 0.2C, and a discharge capacity of 70.8 mAh g–1 at a high rate of 5C, which is superior to that of O3-NaFe0.5Mn0.5O2. The codoping of Cu/Zr reserves the layered O3 structure and enlarges the interlayer spacing, promoting the diffusion of Na+. In addition, the structural stability and air stability observed by Cu-doping is well maintained via the incorporation of extra Zr favoring a highly reversible phase conversion process. Thus, this work has demonstrated an efficient strategy for developing cobalt/nickel-free high-capacity and air-stable cathodes for sodium-ion batteries.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c12684.Rietveld refinement for the XRD pattern of NFMC-0.1 cathode sample; SEM imaging for all the codoped cathode samples, SEM imaging for three cathode samples treated by water immersion; the cyclic curves and the charge–discharge profiles for the codoped cathode samples; the initial charge–discharge curves of NFMCZ-0.01 in different voltage ranges; in situ XRD patterns of NFMCZ-0.01; charge–discharge curves for the three cathode samples after water immersion treatment; the survey spectrum for the codoped cathode sample NFMCZ-0.01 (Figures S1–S8); refined crystal parameters for NFM, NFMC-0.1, and NFMCZ-0.01 by single-phase simulation; comparison of cyclic stability between the previous relevant literature and this work (Tables S1–S4); and detailed procedure to make GITT analysis (PDF)This article has not yet been cited by other publications.

Mitigating voltage decay of O3‐NaNi1/3Fe1/3Mn1/3O2 layered oxide cathode for sodium‐ion batteries by incorporation of 5d metal tantalum

La-doped O3-type Layered Oxide Cathode with Enhanced Cycle Stability for Sodium-Ion Batteries

Trace Ti/Mg Co-Doped O3-type Layered Oxide Cathodes with Enhanced Kinetics and Stability for Sodium-Ion Batteries

Enhanced conduction and phase transition reversibility of O3-type NaNi1/3Fe1/3Mn1/3O2 cathode via Ta doping for high-performance sodium-ion battery

High-entropy configuration of O3-type layered transition-metal oxide cathode with high-voltage stability for sodium-ion batteries

Enhancing the Cycling and Rate Performance of NaNi1/3Fe1/3Mn1/3O2 Cathodes by La/Al Codoping

Zr-doped O3-type NaNi1/3Fe1/3Mn1/3O2 Cathodes with Enhanced Structure Stability for Sodium-Ion Batteries

Mitigating the voltage fading and air sensitivity of O3-type NaNi0.4Mn0.4Cu0.1Ti0.1O2 cathode material via La doping

Air-Stable High-Entropy Layered Oxide Cathode with Enhanced Cycling Stability for Sodium-Ion Batteries

Stabilized O3‐Type Layered Sodium Oxides with Enhanced Rate Performance and Cycling Stability by Dual‐Site Ti4+/K+ Substitution

Toward high stability of O3‐type NaNi1/3Fe1/3Mn1/3O2 cathode material with zirconium substitution for advanced sodium‐ion batteries

Boosting fast ionic transport and stability of O3-NaNi1/3Fe1/3Mn1/3O2 cathode via Al/Cu synergistically modulating microstructure for high-rate sodium-ion batteries

NaTi2(PO4)3 modified O3-type NaNi1/3Fe1/3Mn1/3O2 as high rate and air stable cathode for sodium-ion batteries

High stability of Cu-doped O3-type NaNi1/3Fe1/3Mn1/3O2 cathode material for sodium-ion battery

Enhanced stability and electrochemical performance of O3-type NaNi1/3Fe1/3Mn1/3O2 cathode material via yttrium doping for advanced sodium-ion batteries

Enhanced Cyclability of O3-NaNi 0.33 Fe 0.31 Mn 0.36 O 2 by Mg and Cu Synergistic Doping with Strengthened Mn-O Bonds

High stability of Mo-F dual-doped O3-type NaNi1/3Fe1/3Mn1/3O2 cathode material for sodium-ion battery

O3-Type Na 0.95 Ni 0.40 Fe 0.15 Mn 0.3 Ti 0.15 O 2 Cathode Materials with Enhanced Storage Stability for High-Energy Na-Ion Batteries

Enhancing rate and stability performance of O3-type NiFeMnTi-based layered oxides via Sb/Co dual-doping

Copper and Zirconium Codoped O3-Type Sodium Iron and Manganese Oxide as the Cobalt/Nickel-Free High-Capacity and Air-Stable Cathode for Sodium-Ion Batteries

Refining O3‐Type Ni/Mn‐Based Sodium‐Ion Battery Cathodes via "Atomic Knife" Achieving High Capacity and Stability