Fiber amplification of radially and azimuthally polarized laser light

Moti Fridman,Micha Nixon,Mark Dubinskiy,Asher A. Friesem,Nir Davidson

DOI: https://doi.org/10.1364/OL.35.001332

2010-01-17

Abstract:The results on amplifying either radially or azimuthally polarized light with a fiber amplifier are presented. Experimental results reveal that more than 85% polarization purity can be retained at the output even with 40dB amplification, and that efficient conversion of the amplified light to linear polarization can be obtained.

Optics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to amplify the radially and azimuthally polarized laser beams in fiber amplifiers while maintaining their polarization purity. Specifically, the researchers hope to achieve the following goals:

1. **High - gain amplification**: While maintaining polarization purity, achieve efficient amplification of radially and azimuthally polarized light, reaching a gain of 40 dB.
2. **Maintaining polarization purity**: During the amplification process, ensure that the polarization purity of the output beam exceeds 85%.
3. **Conversion to linearly polarized light**: Verify that the amplified radially and azimuthally polarized beams can be efficiently converted to linearly polarized beams and have a near - Gaussian distribution.

### Background
Radially and azimuthally polarized laser beams have unique properties and symmetries and are particularly suitable for high - power laser systems. The intensity distribution of these beams is annular, and the peak intensity is lower than that of Gaussian - distributed beams, so the nonlinear and damage effects are significantly reduced when passing through the fiber core. However, the output beam power generated by the existing laser resonator configurations is relatively low and requires additional amplification. Although previous studies have achieved such amplification using bulk solid - state laser amplifiers, it has not yet been achieved in fiber amplifiers, which may be due to the adverse effects caused by birefringence and nonlinear effects in the fiber.

### Experimental method
The researchers designed an experimental setup to convert a weakly linearly polarized Gaussian beam into a radially or azimuthally polarized beam through a spatially varying retarder (SVR). These beams were then injected into a ytterbium - doped large - mode - area fiber amplifier for amplification. Three different polarization elements were also used in the experiment to measure the intensity distribution of the beam, thereby obtaining four Stokes parameters to determine the polarization state of the beam.

### Main results
- **Amplification effect**: The experimental results show that the output power reached 400 mW, indicating an amplification gain of 40 dB.
- **Polarization purity**: The polarization purity of the input beam exceeds 95%, and the polarization purity of the amplified beam still remains above 85%.
- **Stability**: The amplified radially and azimuthally polarized beams are stable for several hours in the laboratory environment, with no significant changes in polarization purity and intensity distribution.
- **Conversion efficiency**: The amplified radially polarized beam can be efficiently converted to a linearly polarized beam and has a near - Gaussian distribution, further verifying the high quality of the amplified beam.

### Conclusion
The researchers have successfully achieved efficient amplification of radially and azimuthally polarized beams in fiber amplifiers and maintained a high polarization purity. In addition, they have also shown how to efficiently convert the amplified radially polarized beam to a linearly polarized beam with a near - Gaussian distribution. These results provide new possibilities for the application of high - power laser systems.