Abstract:This paper outlines the design and testing process of the hull of a deep small Autonomous Underwater Vehicle (AUV), rated at 2000m depth. Many existing AUV pressure housings use aluminum or other isotropic traditional metals, instead of composites due to the complexities of the design of composites at such big load. The research at hand explains the process of design starting from setting the geometrical constraints for the design to mass production. To the best of the authors' knowledge, none of the previous studies has presented such detailed description of the work. Carbon fiber reinforced epoxy material was chosen thanks to its high strength-to-weight ratio and similarity of its compressibility to sea water. Material characterization was performed to obtain the material properties under loading conditions using a modified method of the Combined Loading Compression testing technique. A specific fixture was designed and manufactured to test filament-wound tubes. An analytical model was developed using MATLAB, a finite element model was created using ABAQUS, and the results of the two models were compared. A set of recommendations was introduced for the stacking sequence to provide the lowest possible stresses, regardless on the diving depth of the vehicle. Afterwards, a quality control set of tests was conducted, including seawater absorption under high pressure and void analysis using destructive and non-destructive tests. Pilot samples were manufactured and tested in a pressure vessel, where it was cycle-tested and inspected using visual and ultrasonic testing. Other samples were fail-tested and showed a failure at ~93% of the expected failure load. Such range can be considered good to provide safe operation for the vehicle at the designated depth, given that the factor of safety included covers more than 7% of the failure load. The proposed design methodology has shown that CFRE can be- safely used even at such high depths.

Simple Design Method for Ceramic Tube Pressure Housings

Mechanical Analysis of Carbon Fiber Filament Wound Hydrogen Storage Vessel with Aluminum Alloy Liner

Mechanical Analysis and Optimal Design for Carbon Fiber Resin Composite Wound Hydrogen Storage Vessel With Aluminum Alloy Liner

Analysis, Simulation and Experimental Study of the Tensile Stress Calibration of Ceramic Cylindrical Pressure Housings

Mechanical Analysis and Reasonable Design for Ti-Al Alloy Liner Wound with Carbon Fiber Resin Composite High Pressure Vessel

Fabrication and Characterisation of Alumina/aluminium Composite Materials with a Nacre-Like Micro-Layered Architecture

Cost-effective Fabrication of Bio-Inspired Nacre-Like Composite Materials with High Strength and Toughness

Design, modeling and optimization of an adhesively bonded ring joint with U-section for ceramic cylindrical pressure hull of deep-sea underwater vehicles

Rational Design and Porosity of Porous Alumina Ceramic Membrane for Air Bearing

Limit pressure and design criterion of cylindrical pressure vessels with nozzles

Hydrostatic failure behavior of externally pressurized ceramic egg-shaped shells

Strength damage behavior analysis of silicon carbide(SiC) ceramic cylindrical shells under hydrostatic pressure based on the state-based peridynamics

Physical correction factor in ultimate strength calculation of deep-sea pressure-resistant cylindrical shells made of TC4, Ti80 and 18Ni(250)

Scheme Design of Xenon Composite Over-wrapped Pressure Vessel for Electric Propulsion System

Failure Behavior of Corrugated Pressure Cylindrical Shells with Variable Wall Thickness under Uniform External Pressure

Geometric design and energy absorption of a new deployable cylinder tube

Breaking mechanical performance trade-off in 3D-printed complex lattice-inspired multi-cell tubes under axial compression

Improving contact resistance in metal–ceramic heat exchangers running liquid metal by additive manufacturing and ceramic tubes with electroplated films

Strength Analysis of Β″-Al2o3 Ceramics Tubes for Energy Storage Sodium Sulfur Batteries

Design and Testing of a Composite Pressure Hull for Deep Autonomous Underwater Vehicles

Dynamic Response of Ceramic Shell for Titanium Investment Casting under High Strain-Rate SHPB Compression Load