Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

A Study of the Heat Transfer Coefficient of a Mini Channel Evaporator with R-134a as Refrigerant

Investigating the Thermal-Hydraulic Performance of New Refrigerant Mixtures Through Numerical Simulation of Minichannel and Microchannel Evaporators

Visualization of R1233zd(E) Flow Boiling in Parallel Mini-channels

Research on heat transfer property of air-air micro channel evaporator

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Mini Channel Evaporators using R134a in the Design for Vaccine Transport Boxes

Experiment on Boiling Heat Transfer of Refrigerant R134a in Mini-channels

Condensation Heat Transfer and Flow Properties of R134a Refrigerant in Rectangular Minichannel: A Numerical Study

Numerical Investigation of Condensation Heat Transfer Characteristics of R134A in Rectangular Minichannel

Experiments of Condensation Heat Transfer in Micro Channel Heat Exchanger

Phase Change and Heat Transfer Analysis of Different Refrigerants During Condensation in Minichannel Using a Novel Numerical Approach

EXPERIMENTAL STUDY ON EVAPORATING HEAT TRANSFER OF CO2 IN THIN TUBE

Experimental study on condensation heat transfer of R32, R152a and R22 in horizontal minichannels

A numerical study of condensation heat transfer and pressure drop in horizontal round and flattened minichannels

An experimental study on two-phase flow patterns and heat transfer characteristics during boiling of R134a flowing through a multi-microchannel heat sink

Thermal and hydraulic analysis of a brazed aluminum evaporator

Mini Channel Evaporator as MAC Device for Laptop Cooling System

3-D numerical simulation of forced convection heat transfer in microscale rectangular channels for low GWP refrigerants

Evaluation of Heat Transfer Coefficient of Two-Phase Flow Boiling with R290 in Horizontal Mini Channel

Correlation of Evaporation Heat Transfer Inside 8.8 Mm and 7.14 Mm Horizontal Round Micro-Fin Tubes

Experimental Evaluation of Condensation of R32 and R134a over a Plain Tube