MoS 2 /TiO 2 /graphite felt electrode preparation for capacitive deionization device performance improvement

Jung-Jie Huang,Yu-Xuan Zhang,Wei-Chieh Huang,Chien-Sheng Huang,Dong-Sing Wuu
DOI: https://doi.org/10.1016/j.surfcoat.2024.130515
IF: 4.865
2024-02-17
Surface and Coatings Technology
Abstract:In order to improve the desalination effectiveness of a capacitive deionization system, graphite felt (GF) electrodes were modified by TiO 2 and MoS 2 thin films deposition to enhance the wettability and electrochemical characteristics. The influence of varied synthesis concentration ratios of precursor on the proportion of the 1T and 2H phases in MoS 2 was investigated by electrochemistry and desalination tests. The results demonstrated that depositing MoS 2 on GF effectively alleviated the agglomeration problem. An enhanced effect was found when the 1T phase to 2H phase ratio was 1:1. This ratio facilitated in the rapid transport of electrolytic ions and electrons across the electrode surface, resulting in high electrochemical performance. The MoS 2 /TiO 2 /GF electrodes exhibited a specific capacitance value of 257.9 F/g, a desalination efficiency of 34.3 % and a desalination capacity of 40.96 mg/g. After 50 repeated desalination tests, a desalination retention rate of 92.7 % was obtained. The research results verified that the MoS 2 /TiO 2 /GF electrodes have high desalination efficiency and long-term stability, meriting its great potential in the future development of water purification.
physics, applied,materials science, coatings & films
What problem does this paper attempt to address?