Abstract:Silicon photomultipliers (SiPMs) are highly valued for their excellent light response and high gain characteristics, yet their application in fast timing scenarios is often limited by their high terminal capacitance, typically over 300 pF. In electromagnetic calorimeters, sub-nanosecond time measurements allow these detectors to function as supplementary time-of-flight devices, specifically aiming for a time resolution of 150 ps in the NICA-MPD. To address these challenges, this study proposes a novel front-end readout electronics design featuring a two-stage common-base transimpedance preamplifier and a 12-bit 200 MS/s pipelined successive-approximation-register (SAR) analog-to-digital converter (ADC). Extensive SPICE simulations, using the Hamamatsu S13360-6025 as the input source, demonstrate the preamplifier’s rapid rise time and good linearity. Experimental results from laser testing confirm that this fast preamplifier design achieves a remarkable time resolution of better than 20 ps. The ADC circuit, designed using the TSMC65nmLP process, employs a two-stage pipelined SAR structure with a two-step conversion technique (6-bit + 7-bit), incorporating redundancy in the second step. Testing at a 160MHz sampling rate with an 80MHz input condition showed that, at Vpk = -1dBFS, the ADC’s FFT spectrum analysis yielded an effective number of bits (ENOB) of 9.34 and a spurious-free dynamic range (SFDR) of 73.8 dBc. Preliminary System-level timing assessments under a 200 MHz sampling rate revealed that waveforms with 3 to 4 sampling points on the rising edge, with a rise time of 15 to 20 ns, achieved a time resolution of approximately 20 ps.

Design and performance of the front-end electronics of the charged particle detectors of PADME experiment

Characterization and Performance of PADME's Cherenkov-Based Small-Angle Calorimeter

Beam diagnostics with silicon pixel detector array at PADME experiment

Status and Prospects of PADME

First results on the performance of the PADME electromagnetic calorimeter

Development of a new Front End electronics in Silicon and Silicon-Germanium technology for the Resistive Plate Chamber detector for high rate experiments

Development of the front-end electronics for a cost-effective PET-like detector system

The ENUBET positron tagger prototype: construction and testbeam performance

Characterization of the PADME positron beam for the X17 measurement

Design and Operation of Front-End Electronics for the HERA-B Muon Detector

mbedded readout electronics R & D for the large PMTs in the JUNO xperiment

Front-End Board for large area SiPM detector

Enhancing the light yield of He:CF based gaseous detector

Experimental characterization of discrimination capabilities of EJ-276 and EJ-276G read by SiMP by pulse-shape analysis techniques

Front-end-Electronics for the SiPM-readout gaseous TPC for neutrinoless double beta decay search

Enhancing the light yield of He:CF$_4$ based gaseous detector

A Fast Front-end Readout Design for NICA-MPD Shashlik Electromagnetic Calorimeter

Design and test for the CEPC muon subdetector based on extruded scintillator and SiPM

Scintillation Light in SBND: Simulation, Reconstruction, and Expected Performance of the Photon Detection System

Innovative design and construction technique for the Cylindrical GEM detector for the BESIII experiment