Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

Design and Operation of Front-End Electronics for the HERA-B Muon Detector

The Outer Tracker Detector of the HERA-B Experiment. Part II: Front-end Electronics

64 v 1 1 0 D ec 2 00 4 The Outer Tracker Detector of the HERA-B Experiment Part II : Front-End Electronics HERA-B Outer Tracker Group

Development of a new Front End electronics in Silicon and Silicon-Germanium technology for the Resistive Plate Chamber detector for high rate experiments

Compact Frontend-Electronics and Bidirectional 3.3 Gbps Optical Datalink for Fast Proportional Chamber Readout

Design and performance of the front-end electronics of the charged particle detectors of PADME experiment

Scalable DAQ system operating the CHIPS-5 neutrino detector

The design and construction of the MICE Electron-Muon Ranger

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Design and implementation of a ground detection system for HERD-TRD front-end electronics

Low Noise Cold Electronics System for SBND LAr TPC

Architecture of the LHCb muon Frontend control system upgrade

Full-Scale Readout Electronics for the ECHo-100k Experiment

Cold Electronics System Development for ProtoDUNE-SP and SBND LAr TPC

Front-end electronic readout system for the Belle II imaging Time-Of-Propagation detector

Fast Timing Measurement for CMS RPC Phase II Upgrade

Electronics design for a muon imaging system using triangular plastic scintillators with WLS fiber readouts

Front-end electronics for the ALICE calorimeters

Electronics design and testing of the CMS Fast Beam Condition Monitor for HL-LHC

Development of readout electronics a novel beam monitoring system for ion research facility accelerator

Performance Evaluation of the Analogue Front-End and ADC Prototypes for the Gotthard-II Development