Abstract:In the present study, cellulose was effectively separated from eucalyptus wood with ternary solvents containing organic base 1,1,3,3-tetramethyl guanidine and other organic solvents such as morpholine, N-ethyl morpholine, dimethyl formamide, glycerin, ethylene glycol and diethylene glycol. It was found that the combination of 1,1,3,3-tetramethyl guanidine with morpholine was favorable for achieving high delignification and less loss of cellulose. The removal of lignin and hemicellulose achieved 89.8% and 81.4% after heating for 6 h at 160 °C, respectively. It was found that the combination of 1,1,3,3-tetramethyl guanidine with morpholine was favorable for achieving high delignification and less loss of cellulose. The removal of lignin and hemicellulose achieved 89.8% and 81.4% after heating for 6 h at 160 °C, respectively. The addition of morpholine and water promoted the dissolution of lignin and reduced the degradation of cellulose. Subsequently, the crude cellulose was further purified through a simplified bleaching process, the final removal of lignin and hemicellulose increased to 98.7% and 97.5% respectively, and cellulose with a purity of 96.9% was achieved. The scanning electron microscopy analysis indicated that the diameter of cellulose bundles decreased from about 250 μm to about 20 μm after organic solvents treatment. The fiber bundle was completely separated into a single fiber with a diameter of about 5–10 μm after bleaching process. X-ray diffraction analysis revealed an increase in the crystallinity of fiber from 69.4% to 83.3%, implying a reduction of lignin and hemicellulose in eucalyptus. Fourier transform infrared spectra revealed the high selective removal of lignin and hemicellulose. Two-dimensional 1 H- 13 C Heteronuclear singular quantum correlation was performed to investigated the structure units and linkages of lignin and found that only the structural signal of C 5 -H 5 in guaiacyl (G 5 ) alone existed in the aromatic region, while the signals -OCH 3 , C γ –H γ in β-O-4' (A γ ) and β-β' (C γ ) remained in the side chain region, indicating that lignin could be effectively degraded and dissolved by the ternary solvents. In conclusion, high purity cellulose was obtained from eucalyptus wood by environmentally friendly and recyclable processes.

Isolation, Characterization, and Depolymerization of l ‐Cysteine Substituted Eucalyptus Lignin

An Uncondensed Lignin Depolymerized in the Solid State and Isolated from Lignocellulosic Biomass: a Mechanistic Study

An "ideal Lignin" Facilitates Full Biomass Utilization.

Mild Alkaline Pretreatment for Isolation of Native-Like Lignin and Lignin-Containing Cellulose Nanofibers (LCNF) from Crop Waste

Efficient Separation of Eucommia Ulmoides Gum (EUG) and Directed Fabrication of Reconstructed Materials from Eucommia Seed Shell Based on Ingenious Biphasic Solvent System

Characterization of isolated lignin from eucalyptus wood chip obtained by liquid hot water process

Evaluation of Organosolv Pretreatment on the Structural Characteristics of Lignin Polymers and Follow-Up Enzymatic Hydrolysis of the Substrates from Eucalyptus Wood.

Isolation of high-purity residual lignins from eucalypt paper pulps by cellulase and proteinase treatments followed by solvent extraction

Highly selective separation of eucalyptus hemicellulose by salicylic acid treatment with both aromatic and hydroxy acids

Efficient removal of residual lignin from eucalyptus pulp via high-concentration chlorine dioxide treatment and its effect on the properties of residual solids

Lignin with controlled structural properties by N-heterocycle-based deep eutectic solvent extraction

Novel dual-action vanillic acid pretreatment for efficient hemicellulose separation with simultaneous inhibition of lignin condensation

Selective Separation and Recovery of the Lignin from Lignocellulosic Biomass Using Ionic Liquid

Selective lignin arylation for biomass fractionation and benign bisphenols

Optimization of Cosolvent Enhanced Lignocellulosic Fractionation for Isolating Switchgrass Lignin with Distinct Structural Features Using Response Surface Methodology

Fractional separation of cellulose from eucalyptus wood through ternary solvents and simplified bleaching treatment

Co-production of fermentable sugars and highly active lignin from eucalyptus via a mild preprocessing with diethylene glycol and chromic chloride

Catechyl lignin extracted from candlenut by biphasic 2-methyltetrahydrofuran/water: Characterization and depolymerization

Synergy of Single Atoms and Lewis Acid Sites for Efficient and Selective Lignin Disassembly into Monolignol Derivatives.

In‐Depth Identification of Phenolics Fractionated from Eucalyptus Kraft Lignin

The Laccase Catalysed Tandem Lignin Depolymerisation/polymerisation