Abstract:The separation of lignin from black liquor is an attractive option to consider for pulp mills. In modern pulp mills, lignin extraction offers the opportunity of withdrawing an energy surplus in the form of a solid biofuel. The introduction of lignin separation can de-bottleneck pulp mills in which pulp production is limited by recovery boiler capacity. Separated lignin can be used within the mill, e.g. by replacing fuel oil in the lime kiln or fired in a power boiler, or externally e.g. in CHP plants. Today, only half of the wood material (i.e. the cellulose) is used for the production of valuable products. In a more futuristic perspective, separated lignin can be used as a raw material for the production of green chemicals and/or materials replacing oil as a raw material, thus increasing the value created from the wood material. In this thesis, the extraction of lignin in pulp mills, in particular by precipitation from black liquor, was studied with the focus being on quantifying separation properties of the lignin material. After precipitation, the lignin is filtered and washed. Laboratory studies showed that precipitation and filtration is a rather straight-forward process if the right conditions in terms of pH and temperature are used during precipitation. While lignin precipitated from different softwood kraft black liquors taken from the evaporators showed comparable filtration properties, lignin from membrane concentrated black liquors proved to be more difficult to filter. Direct washing of lignin filter cakes proved to be difficult; problems with plugging and uneven washing, in addition to large yield losses, were encountered. These problems were found to be caused by large gradients in pH and ionic strength in the lignin filter cake during washing. A novel washing method was proposed and developed to solve these problems. This process was investigated in laboratory, bench and pilot scale equipment with excellent results in terms of final purity of the lignin product and very low yield losses during separation. Filtration and washing characteristics were quantified and found to be similar in the three different scales that were studied. During the pilot scale trial, more than 8 tonnes of lignin could be produced using the novel separation method, with high levels of purity ( 60%) and calorific value (LHV 25.4 MJ/kg).

Isolation of high-purity residual lignins from eucalypt paper pulps by cellulase and proteinase treatments followed by solvent extraction

Mild Alkaline Pretreatment for Isolation of Native-Like Lignin and Lignin-Containing Cellulose Nanofibers (LCNF) from Crop Waste

Isolation of Highly Crystalline Cellulose via Combined Pretreatment/Fractionation and Extraction Procedures within a Biorefinery Concept

Selective fractionation and enzymatic hydrolysis of Eucalyptus nitens wood

Combination of steam explosion and laccase-mediator treatments prior to Eucalyptus globulus kraft pulping

Characterization of isolated lignin from eucalyptus wood chip obtained by liquid hot water process

A low-cost environmentally friendly approach to isolate lignin containing micro and nanofibrillated cellulose from Eucalyptus globulus bark by steam explosion

Fractional separation of cellulose from eucalyptus wood through ternary solvents and simplified bleaching treatment

Isolation, Characterization, and Depolymerization of l ‐Cysteine Substituted Eucalyptus Lignin

Efficient removal of residual lignin from eucalyptus pulp via high-concentration chlorine dioxide treatment and its effect on the properties of residual solids

Purification and Characterization of a Cellulase-Free, Thermostable Endo-Xylanase from Streptomyces Griseorubens LH-3 and Its Use in Biobleaching on Eucalyptus Kraft Pulp.

Evaluation of Organosolv Pretreatment on the Structural Characteristics of Lignin Polymers and Follow-Up Enzymatic Hydrolysis of the Substrates from Eucalyptus Wood.

Isolation and characterisation of lignin using natural deep eutectic solvents pretreated kenaf fibre biomass

Production of high-quality dissolving pulp from eucalyptus wood chips using deep eutectic solvent and elemental chlorine-free bleaching

Precipitation and separation of lignin from kraft black liquor

Deep eutectic solvent recycling to prepare high purity dissolving pulp

Complete conversion of bleached Kraft pulp into dissolving pulp and two xylo-oligosaccharides through a deep eutectic solvent assisted biorefinery

Preparation of Dissolving Pulp by Combined Mechanical and Deep Eutectic Solvent Treatment

Preparation and Evaluation of High-Lignin Content Cellulose Nanofibrils from Eucalyptus Pulp

Efficient separation and production of high-quality rubber, lignin nanoparticles and fermentable sugars from Eucommia ulmoides pericarp via deep eutectic solvent pretreatment

Lignin recovery from spent alkaline pulping liquors using acidification, membrane separation, and related processing steps: A review