Abstract:Using wood biomass as opposed to petroleum/fossil feedstock to synthesize chemicals and monomers offers the value proposition of a reduced carbon foot print. A critical step in biomass utilization is to obtain the fermentable monomeric pentose and hexose sugar subunits from various lig-nocellulosic polymers. However, lignin is a three-dimensional amorphous polymer based on methoxylated phenylpropanoid units, and is crosslinks to different polysaccharides with covalent bond. The presence of lignin is a barrier to enzymatic hydrosis of cellulose by cellulases, as well as inhibiting fermentation to form products such as ethanol. Usually, there are three approaches to fractionate biomass into useful chemicals. The first one is extract lignin at high temperature and pressure. The second approach involves more severe conditions such as the temperatures and pressures used in gasification, or use the mineral acids at elevated temperatures to liberate sugars for fermentation. The third way is dissolution of biomass using ionic liquid to extract lignin, and then re-precipitation the cellulosic residue. In this paper, we investigate the lignin extraction uses a purpose designed ionic liquid (IL) 1 -butyl-3-methylimidazolium acesulfamate [BMIM]Ace at room temperature and open atmosphere. It was synthesized from the sugar acesulfamate potassium (Ace K), and with good property of greater thermal stability, increased viscosities, and inability to dissolve crystalline cellulose. In addition, it is of low cost and nontoxic, and is expected to interact with lignin owing to its aromatic character of anion. Organic solvents were firstly used in the extraction process, which reduce the viscosity of IL and increase the lignin yield. The lignin can be obtained by using acetone as the reconstitution solvent (IL/acetone 1:3, v/v), and approximately 11.5% and 96.5% of lignin and the reconstitution cellulose-rich material have been achieved in one dissolution/reconstitution cycle by fresh IL, respectively. It was found that the presence of some organic solvents mix with IL can increase the extraction efficiency. The regenerated ionic liquid showed good retention of structure and properties. The regenerated lignin fractions exhibited large molecular weights (M-w, 3700-7810 g mol(-1)). The physicochemical properties of the extracted lignin fractions were characterized by Fourier transform infrared (FT-IR), and high-performance anion exchange chromatography (HPAEC). The reconstitution cellulose-rich material can be serving as a valuable source for enzymatic saccharification for next step. These results indicate a potential approach in further optimization of the choice of low-cost Its combined with organic solvents for the efficient utilization of the wood biomass.

Characterization of isolated lignin from eucalyptus wood chip obtained by liquid hot water process

Evaluation of Organosolv Pretreatment on the Structural Characteristics of Lignin Polymers and Follow-Up Enzymatic Hydrolysis of the Substrates from Eucalyptus Wood.

Selective fractionation and enzymatic hydrolysis of Eucalyptus nitens wood

Isolation, Characterization, and Depolymerization of l ‐Cysteine Substituted Eucalyptus Lignin

Lignin with controlled structural properties by N-heterocycle-based deep eutectic solvent extraction

Efficient extraction of highly reactive lignin from waste mulberry branches

Enhancing the Efficacy of the Subcritical Water-Based Alkali Lignin Depolymerization by Optimizing the Reaction Conditions and Using Heterogeneous Catalysts

Isolation of β-O-4-rich lignin from Birch in high yields enabled by continuous flow supercritical water treatment

One-pot Eucalyptus globulus wood fractionation in acid-catalyzed mixtures of water and 1-pentanol: an optimization study

Hydroliquefaction of lignin: Can it generate recycle solvents by itself?

Physical and Chemical Properties of Acacia mangium Lignin Isolated from Pulp Mill Byproduct for Potential Application in Wood Composites

Extraction and Isolation of Different Lignins from Sugarcane Bagasse Biomass and Its Subsequent Thermal Degradation to Renewable Fuels

Valorization of Lignin to Simple Phenolic Compounds over Tungsten Carbide: Impact of Lignin Structure

Isolation and Structural Characterization of Natural Deep Eutectic Solvent Lignin from Brewer's Spent Grains

Microwave-assisted depolymerization of lignin and a biphasic extraction method for the recovery of bio-oil and phenolic monomers

Purity and structural composition of lignin isolated from Miscanthus x giganteus by sub-critical water extraction with associated modifiers

Extraction Of Lignin From Wood Biomass Using A New Ionic Liquid At Open Atmosphere

High extraction and excellent anti-UV and anti-oxidant proprieties of lignin from Reseda Luteola L. waste by organosolv process

Enhancing Cellulose and Lignin Fractionation from Acacia Wood: Optimized Parameters Using a Deep Eutectic Solvent System and Solvent Recovery

Study on the Relationship between the Structure and Pyrolysis Characteristics of Lignin Isolated from Eucalyptus, Pine, and Rice Straw through the Use of Deep Eutectic Solvent

Enzymatic hydrolysis lignin and kraft lignin from birch wood: a source of functional bio-based materials