Abstract:Doping lanthanum strontium manganite with Ni 2+ at Mn site for 10–30 mol% was investigated as cathode material for LT-SOFC application. Nanopowders were prepared using a simple solution combustion technique and only after calcination at 1200 °C phase purity was obtained. While TEM analysis confirmed particle size around 30 nm, the DLS study showed average most probable size as 13 nm. The SEM-EDAX analysis revealed porous nanopowder of all the studied compositions. It also confirmed composition of the cathode material. In symmetric cell configuration, using lanthanum gallate as electrolyte, oxygen reduction reaction (ORR) and hence polarization resistance (R P ) was studied in detail in the temperature range 500–800 °C. The composition La 0.7 Sr 0.3 Mn 0.8 Ni 0.2 O 3 (LSMN7382) showed lowest R P value of 0.117–0.039 Ω-cm 2 in the temperature range 500–800 °C. In contrast, La 0.7 Sr 0.3 MnO 3 (LSM731) showed much higher R P value. Among the cathodes with Sr 2+ doping variation in La site, 30 mol% showed the best performance. The electrical conductivity of ∼80% dense electrolyte pellets were studied and highest conductivity of 70 S/cm at 800 °C was observed for LSMN7382 among the all compositions. Generation of hole takes place due to the charge compensation in Mn 3+ to Mn 4+ conversion while doping Sr 2+ as well as Ni 2+ . At 30 mol% Ni 2+ doping (LSMN7373), the decrease of conductivity may be attributed to the secondary phase formation. A detailed electrical circuit analysis of the impedance spectrum indicates that charge transfer polarization resistance is the key to control the interface performance. Such high ORR performance by nickel doping can be explained due to Mn 4+ converted to Mn 3+ at high temperature and thus creating oxygen vacancy to enhance ORR ionic path on the cathode surface.

Synthesis and characterization of Ca doped LaMnO3 as potential anode material for solid oxide electrolysis cells

Synthesis and characterization of La0.75Sr0.25Mn0.5Cr0.5-x CuxO3-δ for SOFC anode material

Synthesis And Characterization Of La0.75sr0.25mn0.5cr0.5-Xcuxo3-Delta For Sofc Anode Material

Synthesis and Characterization of La_(0.75)Sr_(0.25)Mn_(0.5)Cr_(0.5-x)Cu_xO_(3-δ) for SOFC Anode Material

Co-synthesized Y-stabilized Bi2O3 and Sr-substituted LaMnO3 Composite Anode for High Performance Solid Oxide Electrolysis Cell

New Electrode of La<sub>0.75</sub>Sr<sub>0.25</sub>Mn<sub>0.5</sub>Cr<sub>0.5-X</sub>Cu<sub>x</sub>O<sub>3-δ</sub> (x=0, 0.05, 0.10, 0.20) for Symmetric Solid Oxide Fuel Cell

Preparation and electrochemical characterization of Sr- and Mn-doped LaGaO 3 as anode materials for LSGM-based SOFCs

Molybdenum-based Double Perovskites A2CrMoO6− (A = Ca, Sr, Ba) As Anode Materials for Solid Oxide Fuel Cells

Synthesis and Evaluation of Ca-doped Sr2Fe1.5Mo0.5O6-δ As Symmetrical Electrodes for High Performance Solid Oxide Fuel Cells

Electrochemical Performance of La0.65Sr0.35MnO3 Oxygen Electrode with Alternately Infiltrated Sm0.5Sr0.5CoO3-δ and Sm0.2Ce0.8O1.9 Nanoparticles for Reversible Solid Oxide Cells

La<SUB>0.3</SUB>Sr<SUB>0.2</SUB>Mn<SUB>0.1</SUB>Zn<SUB>0.4</SUB> Oxide-Sm<SUB>0.2</SUB>Ce<SUB>0.8</SUB>O<SUB>1.9</SUB> (LSMZ-SDC) Nanocomposite Cathode for Low Temperature SOFCs

Preparation and Characterization of La 0.8 Sr 0.2 MnO 3-Δ Cathode for SOFCs Fabricated Using Azeotropic Distillation Method

Electrochemical Characteristics of Solid Oxide Fuel Cell Cathodes Prepared by Infiltrating (la,sr)mno3 Nanoparticles into Yttria-Stabilized Bismuth Oxide Backbones

Electrochemical Performance and Anode Reaction Process for Ca Doped Sr2Fe1·5Mo0·5O6-δ As Electrodes for Symmetrical Solid Oxide Fuel Cells

Development of Lsm-Based Cathodes for Solid Oxide Fuel Cells Based on Ysz Films

Synthesis and characterization of nickel doped LSM as possible cathode materials for LT-SOFC application

La0.6Sr1.4MnO4 Layered Perovskite Anode Material for Intermediate Temperature Solid Oxide Fuel Cells

Coking-Resistance and Sulfur-Tolerance Study of La0.4Sr0.6Co0.2Fe0.7Nb0.1O3-δ Anode

Bismuth-Doped La1.75sr0.25nio4+Delta As A Novel Cathode Material For Solid Oxide Fuel Cells

Highly active and stable Er0.4Bi1.6O3 decorated La0.76Sr0.19MnO3+δ nanostructured oxygen electrodes for reversible solid oxide cells

Synthesis and Ionic Conductivity of Lanthanum-based Ceria Ce1−xLaxO2−δ Electrolytes for Solid Oxide Fuel Cell Applications