Nanocrystalline soft magnetic materials from binary alloy precursors with high saturation magnetization

K. Suzuki,R. Parsons,B. Zang,K. Onodera,H. Kishimoto,T. Shoji,A. Kato

DOI: https://doi.org/10.1063/1.5079778

IF: 1.697

2019-03-01

AIP Advances

Abstract:A brief survey of the recent advances in Fe-based nanocrystalline soft magnetic alloys has shown that the saturation magnetization (<i>J</i>_s) of these alloys is governed by the mass fraction, rather than the atomic fraction, of the nonmagnetic additives. Thus, the ultimate limit of <i>J</i>_s in the alloys prepared by nano-crystallization of amorphous precursors is expected in an Fe-B binary system where amorphization by rapid quenching takes place with the lowest mass fraction of glass forming elements in Fe-based systems. We will demonstrate that nano-crystallization is possible in this binary system when the precursor amorphous phase is annealed ultra-rapidly. While the grain size after conventional annealing for amorphous Fe-B alloys is too large for the exchange softening effect, a small grain size well below the exchange length is obtained after annealing with a heating rate of 10³ – 10⁴ K/s. This results in magnetically soft nanostructures with Fe content up to 97.2 wt. %, leading to a high <i>J</i>_s ≥ 1.9 T with a small coercivity (<i>H</i>_c) between 3.8 and 6.4 A/m. An addition of Co to nc-Fe₈₇B₁₃ results in a higher <i>J</i>_s of 2.0 T with a slight increase of <i>H</i>_c to 9.3 A/m. The soft magnetic properties of these ultra-rapidly annealed alloys (named HiB-Nanoperm) is well understood by the random anisotropy model. The formation of nano-meter scale microstructures in a simple binary system unlocks previously unavailable alloy design strategies in nanostructured systems which is not only relevant to magnetic materials but, also to structural materials.

materials science, multidisciplinary,physics, applied,nanoscience & nanotechnology