Abstract:New Fe82-85B13-16Si1Cu1 amorphous alloys with low B content and high B/Si content ratios were synthesized by melt spinning for developing good soft magnetic and high strength materials. The crystallization occurs through two stages and the first-stage onset temperature increases from 673 K to 705 K with increasing B content, while the second-stage temperature remains nearly constant. The first and second stages are due to the precipitation of the α-Fe(Si) phase with a size of about 30 nm and the decomposition of the remaining amorphous phase to α-Fe(Si)+Fe3B+Fe2B, respectively. The Fe-based alloys exhibited good soft magnetic properties both in annealed amorphous and nanocrystallized amorphous+α-Fe(Si) phases. The saturated magnetic flux density, coercivity and permeability at 1 kHz are 1.7 T, 4.92 A/m and 7100, respectively, for the annealed amorphous 14B alloy and 1.74 T, 5.62 A/m and 10100, respectively, for the nanocrystallized 13B alloy. The Vickers hardness (H v) is 803–867 for the as-spun state and it increases with decreasing B content. The H v increases significantly by crystallization to α-Fe+amorphous phases and reaches 997–1550 for the alloys annealed at 693–763 K just before T x2. The ultrahigh H v is presumably due to the combination of fine nanoscale mixed phases, high volume fraction of α-Fe(Si) without internal defects and the enrichment of B into the remaining amorphous phase. Such ultrahigh H v has not been obtained for Fe-based amorphous and crystallized alloys before and the addition of 1%Cu is essential for the ultrahigh H v and the amorphous phase formation for the Fe-rich 85%Fe alloy. The new Fe-based alloys are encouraging as future soft magnetic and ultrahigh strength materials with low material cost.

A Plastic Iron-Based Nanocrystalline Alloy with High Saturation Magnetic Flux Density and Low Coercivity Via Flexible-Annealing

Fe65B22Nd9Mo4 bulk nanocomposite permanent magnets produced by crystallizing amorphous precursors

Ductile Fe-based amorphous alloy with excellent soft magnetic properties induced by low-temperature stress annealing

Exceptionally High Saturation Magnetic Flux Density and Ultra‐low Coercivity Via an Amorphous‐nanocrystalline Transitional Microstructure in a FeCo‐based Alloy

Design of Fe-based nanocrystalline alloys with superior magnetization and manufacturability

Exceptionally High Saturation Magnetic Flux Density and Ultralow Coercivity Via an Amorphous–Nanocrystalline Transitional Microstructure in an FeCo‐Based Alloy

High performance Fe-based nanocrystalline alloys with excellent thermal stability

Ultra-fine microstructure and exceptional low coercivity developed in a high-Bs Fe-Si-B-P alloy by co-alloying Ni, Mo, and Cu

A unique Fe-based soft magnetic alloy and its magnetic softening mechanism

Tailoring the microstructure and soft magnetic properties of (Fe0.83B0.11Si0.02P0.03C0.01)99.5Cu0.5 nanocrystalline alloy based on the rapid annealing

Nanocrystallization, magnetic properties and bending ductility of antiferromagnetic Mn-doped FeSiBCuPC alloys induced by micro-compressive stress annealing

Fe-B-Si-C-Cu amorphous and nanocrystalline alloys with ultrahigh hardness and enhanced soft magnetic properties

Deep supercooling solidification towards tuned amorphous/nanocrystalline dual phases for superior magnetic nanocrystalline alloys

Nanocrystallization, good soft magnetic properties and ultrahigh mechanical strength for Fe82-85B13-16Si1Cu1 amorphous alloys

Ultrahigh Permeability at High Frequencies via A Magnetic‐Heterogeneous Nanocrystallization Mechanism in An Iron‐Based Amorphous Alloy

Rapid Annealing Optimizing Magnetic Softness and Thermal Stability of Mn-Substituted Fe-Based Nanocrystalline Alloys

Improvement of soft-magnetic properties for Fe-based amorphous alloys with high saturation polarization by stress annealing

Improving the Amorphous Forming Ability and Magnetic Properties of FeSiBPCu Amorphous and Nanocrystalline Alloys by Utilizing Carbon

Enhanced thermal-operating stability of high-frequency magnetic behavior for FeMnSiBNbCu nano-structural cores via field-annealing

Influence of microstructure on soft magnetic properties of low coreloss and high Bs Fe85Si2B8P4Cu1 nanocrystalline alloy

Ultrafine-grained microstructure and controllable magnetic domains in Fe-based nanocrystalline alloys with excellent magnetic properties induced by hot isostatic pressing