Preparation of a novel laser cladding Ni-based alloy with promising applications in high-temperature conditions: Genetic design, multi-phase evolution, and synergy mechanism
Youcai Zhang,Suiyuan Chen,Yue Wang,Jialu Chen,Ting Wang,Tong Cui,Jing Liang,Xiaotao Sun
DOI: https://doi.org/10.1016/j.addma.2024.104589
IF: 11
2024-12-06
Additive Manufacturing
Abstract:Developing novel Ni-based alloys is crucial for remanufacturing key friction parts at 800-1200 °C in metallurgical industry with multiple failure mechanisms, such as wear, corrosion, and adhesion. This paper adopts genetic algorithm to design high-temperature Ni-based alloy with three genetic structures of wear resistance, anti-corrosion, and self-lubricating. By combining simulation calculation and experimental methods, the evolution of the three genetic structures of the laser cladding alloy and the performance strengthening mechanism were deeply studied. The laser clad Ni17Cr10Co7Al5Ti3W2C1S sample of optimized composition had three genetic structures: Cr 7 C 3 /TiC wear resistance phases, γ/γ′ anti-oxidation and anti-corrosion phases, Ti 2 SC/TiS self-lubricating phases. Compared with Cr28Ni48W5 superalloy, the wear rate of the optimal sample was 2.31×10 -5 mm 3 /(N·m) under 800 °C friction condition, and reduced by 97%. The friction coefficient of the sample at high temperature was 0.2, approximately half of the substrate alloy, and the self-lubricating performance was significantly improved. Electrochemical tests indicated that the polarizing potential of the sample was -0.16 V SCE in 3.5 wt. % NaCl solution. The mechanism of three genetic structures evolution and synergistic enhanced wear resistance, anti-corrosion, and self-lubricating properties were elaborated. Specifically, the key gene of Ti 2 SC plays a profound role in improving the high-temperature wear resistance and self-lubricating performance of the novel laser clad Ni-based alloy sample. These findings present a novel avenue of material design and preparation for laser additive manufacturing and remanufacturing of key friction parts with high-performance at 800-1200 °C in complex metallurgical working conditions.
engineering, manufacturing,materials science, multidisciplinary