Abstract:This article presents an ultra-broadband load-insensitive Doherty power amplifier (DPA) MMIC for fifth-generation (5G) smartphones to mitigate performance loss due to hand effects and mutual coupling effects. By adjusting supply voltages and input settings, we reconfigure the optimal output impedance of main and auxiliary PAs, and further preserve the back-off (BO) output power ( ${P}_{{\text{BO}}}$ ), saturated output power ( ${P}_{{\text{max}}}$ ), as well as power-added efficiency ( $\text{PA}{{{E}}_{\text{BO}}}$ and $\text{PA}{{{E}}_{\text{max}}}$ ). More importantly, this mismatch compensation theory is then expanded and validated in broadband DPA MMIC designs. As a proof of concept, a broadband load-insensitive dual-input DPA MMIC is fabricated using SANAN 250-nm GaAs HBT process. The prototype demonstrates cutting-edge performance, achieving 39 $\%$ –44.5 $\%$ $\text{PA}{{{E}}_{\text{max}}}$ at ${P}_{{\text{max}}}$ ranging from 34.2 to 35.1 dBm, and 35 $\%$ –39 $\%$ $\text{PA}{{{E}}_{\text{BO}}}$ at a 6-dB output BO (OBO) level in 1.7–2.7 GHz. Additionally, the proposed DPA MMIC showcases remarkable mismatch resilience over a full-span 2.5:1 voltage standing wave ratio (VSWR) circle. Specifically, the compensated $\text{PA}{{{E}}_{\text{max}}}$ ranges from 31.5 $\%$ to 43 $\%$ , corresponding to ${P}_{{\text{max}}}$ between 33 and 34.4 dBm, while at the 6-dB OBO power level, $\text{PA}{{{E}}_{\text{BO}}}$ is within the range of 30 $\%$ –38 $\%$ in 1.7–2.7 GHz. Moreover, when driven by a 100-MHz single-carrier 64-quadratic-amplitude modulation (QAM) signal with 6.5-dB peak-to average power ratio (PAPR), at a 50- $\Omega$ load, the DPA achieves an adjacent channel leakage ratio (ACLR) less than $-$ 26.4 dBc and an rms error vector magnitude (EVM) of $-$ 26/ $-$ 25 dB for 1.7–2.7 GHz. Under a full-span 2.5:1 VSWR, the average output power and average PAE are measured at 26.5–27.9 dBm and 26.5 $\%$ –35 $\%$ , respectively, with an EVM below $-$ 22 dB and an ACLR less than $-$ 25.5 dB.

CMOS Power Amplifier Integrated Circuit With Dual-Mode Supply Modulator for Mobile Terminals

CMOS Power Amplifier Integrated Circuit With Dual-Mode Supply Modulator for Mobile Terminals

A 60-Ghz Cmos Dual-Mode Power Amplifier with Efficiency Enhancement at Low Output Power

A 28-GHz CMOS Linear Power Amplifier With Low Output Phase Variation Over Dual Power Modes

A Fully-Integrated Dual Band CMOS Power Amplifier Based on an Active Matching Transformer

A Dual-Mode CMOS Power Amplifier with an External Power Amplifier Driver Using 40 nm CMOS for Narrowband Internet-of-Things Applications

A 700 MHz-920 MHz CMOS Power Amplifier for LTE Applications

A Quad-Band CMOS Linear Power Amplifier for EDGE Applications Using an Anti-Phase Method to Enhance its Linearity

High Efficiency AC-Coupling Hybrid Envelope Tracking Supply Modulator for LTE Applications

Fully-Integrated Two-Stage GaN MMIC Doherty Power Amplifier for LTE Small Cells

A Dual-Band High-Efficiency Power Amplifier in 65-Nm CMOS Technology

A CMOS class-E Power Amplifiers with Power Control

Multi-Band Power Amplifier Module with Back-Off Efficiency Improvement using Ultra-Compact 3D Vertical Stack Multi-Chip Package for Cellular Handsets

A Ka-Band CMOS Power Amplifier With OP1dB Improvement Employing a Diode-Connected Analog Linearizer

Digitally Equalized CMOS Transmitter Front-End with Integrated Power Amplifier

A 18mW 20-MHz continuous-time ΔΣ modulator for LTE communication system with power efficient multi-stage amplifier

An Ultra-Broadband Load-Insensitive Dual-Input Doherty Power Amplifier MMIC Using Configurable Supply Voltage for 5G Smartphones

A flip-chip-packaged 1.8V 28dBm class-AB power amplifier with shielded concentric transformers in 32nm SoC CMOS.

A 2×2 MIMO multi-band RF transceiver and power amplifier for compact LTE small cell base station

A CMOS Wideband Watt-Level 4096-QAM Digital Power Amplifier Using Reconfigurable Power-Combining Transformer

A 0.15-Μs/v Buck-Boost Symbol-Power-Tracking Supply Modulator with Dual Auxiliary Current Paths and EPP Scheme for 5G NR Power Amplifiers