Abstract:This research investigated a feasible approach to fabricating electrically conductive knitted fabrics using previously wet-spun wool/polyacrylonitrile (PAN) composite fibre. In the production of the composite fibre, waste wool fibres and PAN were used, whereby both the control PAN (100% PAN) and wool/PAN composite fibres (25% wool) were knitted into fabrics. The knitted fabrics were coated with graphene oxide (GO) using the brushing and drying technique and then chemically reduced using hydrazine to introduce the electrical conductivity. The morphological study showed the presence of GO sheets wrinkles on the coated fabrics and their absence on reduced fabrics, which supports successful coating and a reduction of GO. This was further confirmed by the colour change properties of the fabrics. The colour strength (K/S) of the reduced control PAN and wool/PAN fabrics increased by ~410% and ~270%, and the lightness (L*) decreased ~65% and ~71%, respectively, compared to their pristine fabrics. The Fourier transform infrared spectroscopy showed the presence and absence of the GO functional groups along with the PAN and amide groups in the GO-coated and reduced fabrics. Similarly, the X-ray diffraction analysis exhibited a typical 2θ peak at 100 that represents the existence of GO, which was demolished after the reduction process. Moreover, the wool/PAN/reduced GO knitted fabrics showed higher electrical conductivity (~1.67 S/cm) compared to the control PAN/reduced GO knitted fabrics (~0.35 S/cm). This study shows the potential of fabricating electrically conductive fabrics using waste wool fibres and graphene that can be used in different application fields.

Improving Thermal and Electrical Efficiency in Lightweight Aluminium Wires Through Graphene Coating via Electrophoretic Deposition

Industrial graphene coating of low-voltage copper wires for power distribution

Study on Pulse-Reverse Electroplating Process for the Manufacturing of a Graphene-Based Coating

Electrical property enhancement of non-heat-treatable wrought aluminum alloys using graphene additives

An Axially Continuous Graphene-Copper Wire for High-Power Transmission: Thermoelectrical Characterization and Mechanisms

Improved Mechanical Property and Corrosion and Wear Resistance of High-Voltage Aluminium Wires by Micro-Arc Oxidation Coating

Morphological and functional characterization of electroplated Ni-graphene composite coatings

Progress and Current Status in Research on Nanostructured Cu-Ag Microcomposites for Conductor Wires

An Investigation of Electric Resistance of Graphene-Coated Copper Thin Film from First Principles

Investigating Tribological Properties of Electrophoretically Deposited Graphene Nanoplatelets Coatings on Mild Steel

Fabrication and characterization of copper and copper alloys reinforced with graphene

Composite electroplating to enhance the GMI output stability of melt-extracted wires

Surface Oxidation Engineering for Enhanced Interface Bonding Achieving Excellent Electronic Properties in Multilayer Nitrogen Doped Graphene/cu Composites Wires

Fabrication Of A New Ceramic Coating By Electrophoretic Method For Graphite Electrodes At High Temperature

Design Strategy to Simultaneously Enhance Electrical Conductivity and Strength: Cold-Drawn Copper-Based Composite Wire with In-Situ Graphene

Improvement of the Heat-Dissipating Performance of Powder Coating with Graphene

A Facile Approach of Fabricating Electrically Conductive Knitted Fabrics Using Graphene Oxide and Textile-Based Waste Material

Enhancing thermal conductivity of 6061 Al plate via graphene dip coating

Aramid nanofiber framework supporting graphene nanoplate via wet-spinning for a high-performance filament

Achieving high strength and electrical properties in drawn fine Cu matrix composite wire reinforced by in-situ grown graphene

Enhanced Wear Resistance and Thermal Dissipation of Copper–Graphene Composite Coatings via Pulsed Electrodeposition for Circuit Breaker Applications