Abstract:Monocore powder-in-tube MgB2 strands were cold-drawn and heat-treated at 600C and 700C for times of up to 71 hours and structure-property relationships examined. Drawing-induced elongation of the Mg particles led, after HT, to a textured macrostructure consisting of elongated polycrystalline MgB2 fibers separated by elongated pores. The superconducting Tc, Jc and Fp were correlated with the macrostructure and grain size. Grain size increased with HT time at both 600C and 700C. Jc and hence Fp decreased monotonically but not linearly with grain size. Overall, it was observed that at 700C, the MgB2 reaction was more or less complete after as little as 30 min; at 600C, full reaction completion did not occur until 71 h. into the HT. Transport, Jct(B) was measured in a perpendicular applied field, and the magnetic critical current densities, Jcm\bot(B) and Jcm{\phi}(B), were measured in perpendicular and parallel (axial) applied fields, respectively. Particularly noticeable was the premature dropoff of Jcm\bot(B) at fields well below the irreversibility field of Jct(B). This effect is attributed to the fibrous macrostructure and its accompanying anisotropic connectivity. Magnetic measurements with the field directed along the strand axis yielded a critical density, Jcm\bot(B), for current flowing transversely to the strand axis that was less than and dropped off more rapidly than Jct(B). In the conventional magnetic measurement, the loop currents that support the magnetization are restricted by the lower of Jct(B) and Jcm{\phi} (B). In the present case the latter, leading to the premature dropoff of the measured Jcm(B) compared to Jct(B) with increasing field. This result is supported by Kramer plots of the Jcm{\phi} (B) and Jct(B) data which lead to an irreversibility field for transverse current that is very much less than the usual transport-measured longitudinal one, Birr,t.

The influence of the HIP process on the microstructure, critical temperature and critical current density of double-doped (with Dy2O3 + C, and Tb2O3 + C) MgB2 bulk compounds

Effect of Heat Treatments under High Isostatic Pressure on the Transport Critical Current Density at 4.2 K and 20 K in Doped and Undoped MgB2 Wires

Influence of Amorphous Boron Grain Size, High Isostatic Pressure, Annealing Temperature, and Filling Density of Unreacted Material on Structure, Critical Parameters, n-Value, and Engineering Critical Current Density in MgB2 Wires

Inhomogeneity of Magnesium Diboride Structure and its Effect on Critical Current Density

Effect of grain refinement on enhancing critical current density and upper critical field in undoped MgB2 ex-situ tapes

Effects of TiC Doping on the Upper Critical Field of MgB2 Superconductors

Structural and critical current properties in Al-doped MgB2

Influences of Heat Treatment and Doping on Microstructure and Superconducting Properties of MgB2 Superconductor

High temperature heat treatment of B precursor and P.I.T. process optimization to increase Jc performances of MgB2-based conductor

Effect of the processing parameters of MgB1.8(SiC)0.1/Fe tapes on the critical current density

Drawing induced texture and the evolution of superconductive properties with heat treatment time in powder-in-tube in-situ processed MgB2 strands

Magnetic characterization of sintered MgB2 samples: effect of the substitution or doping with Li, Al and Si

The Effect of Zrsi2 and Sic Doping on the Microstructure and J(C)-B Properties of Pit Processed Mgb2 Tapes

Significant Improvements of the High-Field Properties of Carbon-Doped MgB2 Films by Hot-Filament-assisted Hybrid Physical–chemical Vapor Deposition Using Methane As the Doping Source

Microstructure and high critical current of powder in tube MgB2

Effect of Nano-SiC and Nano-Si Doping on Critical Current Density of MgB 2

Superconducting Properties of adipic acid doped Bulk MgB2 Superconductor

Enhancement of the Critical Current Density and the Irreversibility Field in Maleic Anhydride Doped MgB2 Based Tapes

Improvement of Critical Current Density and Upper Critical Field in MgB2 using Carbohydrate

Investigation of Layered Structure Formation in MgB2 Wires Produced by the Internal Mg Coating Process under Low and High Isostatic Pressures

Titanium additions to MgB2 conductors