Abstract:Solid–liquid two-phase flowmeters are widely used in critical sectors, such as petrochemicals, energy, manufacturing, the environment, and various other fields. They are indispensable devices for measuring flow. Currently, research has primarily focused on gas–liquid two-phase flow within the flowmeter, giving limited attention to the impact of solid phases. In practical applications, crude oil frequently contains solid particles and other impurities, leading to equipment deformation and a subsequent reduction in measuring accuracy. This paper investigates how particle dynamic parameters affect the erosion evolution characteristics of flowmeters operating in solid–liquid two-phase conditions, employing the dynamic boundary erosion prediction method. The results indicate that the erosion range and peak erosion position on the overcurrent wall of the solid–liquid two-phase flowmeter vary with different particle dynamic parameters. Erosion mainly occurs at the contraction section of the solid–liquid two-phase flowmeter. When the particle inflow velocity increases, the erosion range shows no significant change, but the peak erosion position shifts to the right, primarily due to the evolution of the erosion process. With an increase in particle diameter, the erosion range expands along the inlet direction due to turbulent diffusion, as particles with lower kinetic energy exhibit better followability. There is no significant change in the erosion range and peak erosion position with an increase in particle volume fraction and particle sphericity. With a particle inflow velocity of 8.4 m/s, the maximum erosion depth reaches 750 μm. In contrast, at a particle sphericity of 0.58, the minimum erosion depth is 251 μm. Furthermore, a particle volume fraction of 0.5 results in a maximum flow coefficient increase of 1.99 × 10−3.

Performance of construction materials in multiphase liquid/solid flows

Predicting Erosion-Corrosion Induced by the Interactions Between Multiphase Flow and Structure in Piping System

Numerically Investigating the Influence of Local Flow Behaviors on Flow-Accelerated Corrosion Using Two-Fluid Equations

Failure analysis and prediction of pipes due to the interaction between multiphase flow and structure

Flow Velocity and Sand Loading Effect on Erosion–Corrosion during Liquid-Solid Impingement on Mild Steel

Erosion-corrosion Failure of REAC Pipes under Multiphase Flow

Flow-Induced Corrosion Simulation on a Plate by Finite Element Methods

Multi-Scale Simulation of Fluid-Structure Interaction Induced Erosion on the Pipe Surface

ICONE19-43282 TURBULENCE MODELING FOR MASS TRANSFER IN SEPARATED AND REATTACHING FLOWS FOR FLOW-ACCELERATED CORROSION

Application of Local Flow Models in Predicting Distributions of Erosion-Corrosion Locations

A comprehensive review on the flow characteristics and erosion wear of the various multi-phase flow handling equipment

Numerical Predictions of Uniform CO2 Corrosion in Complex Fluid Domains Using Low Reynolds Number Models

Solid–Liquid Two-Phase Flowmeter Flow-Passage Wall Erosion Evolution Characteristics and Calibration of Measurement Accuracy

Predictions of Hydrodynamic Characteristics and Corrosion Rates Using CFD in the Piping Systems of Pressurized-Water Reactor Power Plant

Numerical simulation of pressure loss and flow characteristics in combined elbow pipes for solid-liquid two-phase flow

Erosive Wear Caused by Large Solid Particles Carried by a Flowing Liquid: A Comprehensive Review

PRELIMINARY EXPERIMENTAL STUDY ON EROSION-CORROSION BEHAVIOR OF SECOND LOOP PIPELINE IN NUCLEAR POWER PLANT WITH VAPOR LIQUID TWO PHASE FLOW

A New Approach for Investigation of Erosion-Corrosion Using Local Flow Models

An Improved Method Combined Modified Drag Model and Modified Erosion Model Based on LES for Solid-Liquid Multiphase Flow and Erosion with Application in a 90° Elbow

Simulation Analysis of Erosion-Corrosion Behaviors of Elbow under Gas-Solid Two-Phase Flow Conditions

Pipe bend erosion CFD modeling for two-phase liquid–solid slurry