Abstract:To support future ITER operation, experimental campaigns at the Joint European Torus (JET) with an ITER-like wall (tungsten divertor and beryllium main chamber) in pure deuterium (D), tritium (T) and Deuterium-Tritium (D-T) were performed. One of the most important challenges in recent years was the development of two main scenarios that investigated different approaches to achieve the high fusion power as well as good plasma confinement (Garzotti et al., 2023). The first one, so-called baseline scenario is relying on high plasma current (I p ≈3.5 MA), normalized beta β N < 2 and safety factor q 95 ≈ 3 (Garzotti et al., 2023). On the other hand, the second one, so-called Hybrid scenario is operating at lower plasma current (flat-top I p ≤ 2.6 MA) and density with respect to the baseline, higher normalized beta β N > 2 and safety factor q 95 ≈ 4.8 (Hobirk et al., 2023). In this paper we focus on the impurity behaviour analysis for the baseline discharges at I p = 3.5 MA and B T = 3.3 T with D, T and DT plasmas, in which the gas and power waveform were optimized to achieve the best possible performance. In particular, we study the impact of total heating power (P tot + P alpha ), flat-top gas flow and ELM (edge localized modes) frequency on mid-Z (Nickel (Ni), Copper (Cu)) and high-Z (Tungsten (W)) impurities. In addition, we compared the two best performing pulses of the baseline scenario (I p = 3.5MA, B T = 3.3 T and P in ≈ 35 MW) in D and DT in order to identify the causes responsible for the increase in radiation during the DT pulse, which led to an early plasma termination. All presented results rely on the data collected by the VUV as well as the bolometry system. Detailed analysis indicates that in the baseline scenario, higher radiation, which is most likely due to the tungsten (W), is observed for T and DT plasmas in comparison to D. Moreover, for the two best performing baseline pulses, tomographic reconstructions show that the radiated power density is mainly emitted from the low field side (LFS) of the plasma and W does not accumulate in the plasma center (Telesca et al., 2024).

Shielding of a Tungsten Target From Impact of a Powerful Hydrogen Plasma Flow by Means of a Nitrogen Gas Screen

Nanostructure Evolution and Surface Modification of Tungsten Exposed to Low Energy, High Flux Deuterium Plasma

Influence of Nitrogen Pre-Irradiation at Different Temperatures on Surface Blistering and Deuterium Retention in Tungsten

Influence of AR injection on shielding layer properties and surface protection from transient high heat loads under the QSPA plasma exposures

Recent Studies of Tungsten-Based Plasma-Facing Materials in the Linear Plasma Device STEP

Hydrogen Behaviors at the Near-Surface Region of Tungsten: A First-Principles Study

Formation process of tungsten nanostructure by the exposure to helium plasma under fusion relevant plasma conditions

Reduced D Trapping by Plasma-Implanted He Nanobubbles in Radiation Damaged Tungsten

Study of the Effect of Shielding Gas on the Plasma Flow of an Electric Arc and on the Droplet of a Molten Metal

Tungsten Material Behavior under H2, D2, and He Plasma Interaction Conditions in the Framework of Fusion-Relevant Studies

Bubble Formation in ITER-Grade Tungsten after Exposure to Stationary D/He Plasma and ELM-like Thermal Shocks

Study of Nanostructured Layer Growth on Plasma-Facing Materials Irradiated with Helium Plasma

Impurity behaviour in JET high-current baseline scenario for Deuterium, Tritium and Deuterium-Tritium plasmas

Review of Irradiation Damage Behavior of Tungsten Exposed to Plasma in Nuclear Fusion

Oscillatory vapour shielding of liquid metal walls in nuclear fusion devices

Study of interaction between low energetic hydrogen and tungsten surface by molecular dynamics simulations

Deuterium-induced Nanostructure Formation on Tungsten Exposed to High-Flux Plasma

Evaluation of tungsten as a hydrogen permeation barrier in reduced activation steel F82H for nuclear fusion applications

Spatially dependent cluster dynamics model of He plasma surface interaction in tungsten for fusion relevant conditions

Generation of Soft X-Ray and Vacuum Ultraviolet Radiation during the Interaction of a Hydrogen Plasma Flow with a Gas Jet

Response of tungsten surfaces to helium and hydrogen plasma exposure under ITER relevant steady state and repetitive transient conditions