Detection of non-Gaussian Fluctuations in a Quantum Point Contact

G. Gershon,Yu. Bomze,E. V. Sukhorukov,M. Reznikov

DOI: https://doi.org/10.1103/PhysRevLett.101.016803

2009-01-20

Abstract:An experimental study of current fluctuations through a tunable transmission barrier, a quantum point contact, are reported. We measure the probability distribution function of transmitted charge with precision sufficient to extract the first three cumulants. To obtain the intrinsic quantities, corresponding to voltage-biased barrier, we employ a procedure that accounts for the response of the external circuit and the amplifier. The third cumulant, obtained with a high precision, is found to agree with the prediction for the statistics of transport in the non-Poissonian regime.

Mesoscale and Nanoscale Physics,Statistical Mechanics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: How to accurately measure the third cumulant of non - Gaussian current fluctuations in a quantum point contact (QPC), and reliably extract the intrinsic third current cumulant corresponding to the voltage - biased system from experimental data.

### Specific problem description:

1. **Measurement of non - Gaussian current fluctuations**:
- Usual mesoscopic physics experiments mainly report zero - frequency noise power, but this can only provide partial information about the statistics of transferred charges. To more comprehensively understand the statistical properties of current fluctuations, higher - order cumulants need to be measured.
- The third cumulant \( \langle\langle J^3 \rangle\rangle \) is a simple indicator of non - Gaussianity, reflecting the skewness of the current distribution. It is linear and universal at low bias voltages, so it can be used as a tool to study strongly correlated systems.

2. **Separation of environmental and circuit effects**:
- In typical experiments, due to the discreteness of electrons, the voltage across the sample is not constant, so the measured statistics do not directly correspond to the counting statistics (CS) of the voltage - biased system.
- There are also "cascade corrections" in the experiment. These corrections come from the reaction of the measurement device on the sample and the nonlinear effects of the sample. These correction terms may be of the same order of magnitude as the third current cumulant \( \langle\langle J^3 \rangle\rangle \), making direct measurement complicated.

### Solutions:

- **Experimental design**:
- Use a quantum point contact as an adjustable transmission barrier and gradually adjust the confinement width by changing the gate voltage \( V_g \).
- Adopt an improved amplifier setup, increase the total gain of the amplification chain to fully utilize the resolution of a 12 - bit analog - to - digital converter (A/D), and reduce the nonlinearity of the cryogenic amplifier.

- **Data analysis**:
- Develop a technique that can reliably subtract the environment - and circuit - dependent contributions from the experimental data, thereby extracting the intrinsic third current cumulant \( \langle\langle J^3 \rangle\rangle \).
- Calibrate the setup by introducing a known AC signal and calculate the necessary coefficients using a complex frequency - response function \( A(\omega) \).

### Experimental results:

- The measured third current cumulant \( \langle\langle J^3 \rangle\rangle \) agrees very well with theoretical predictions, verifying the expectations of the non - interacting fermion model.
- For two different samples (QPC1 and QPC2), even when using amplifiers with different frequency characteristics, the results also show good consistency, further demonstrating the effectiveness of this method.

### Summary:

This research has successfully solved the problem of accurately measuring the third cumulant of non - Gaussian current fluctuations in a quantum point contact and developed a reliable experimental method to separate environmental and circuit effects. This paves the way for using higher - order cumulants as experimental tools in mesoscopic physics.