Abstract:Phased arrays have demonstrated great potential in 5/6G communication, radar and sensor applications [1– 4]. To achieve excellent performance, phased arrays require low-noise and high-linearity front-ends [5]. Most importantly, arrays demand uniform performance from all elements for optimum receiving G/T value and transmission effective isotropic radiated power (EIRP) [6]. Figure 14.7.1 exemplifies it with an array whose antenna element has 3dBi uniform gain on one side and no radiation on the other side. When all elements in an $8 \\times 1$ linear array with a $\\lambda/2$ space have identical characteristics, the array presents a 19dBi gain in the normal direction. Any temperature change in the array can be decomposed into an absolute temperature change superposed with a relative temperature variation. When the absolute temperature increases, the frontend gain decreases by as much as $-0.1dB/^{\\circ}C$ [1]. When there is non-uniform solar radiation or heat generation inside the array, the relative temperature variation may present a gradient or a parabolic distribution. Taking a $64 \\times1$ array as an example, when there is a gain/phase mismatch with an average value of $0.125dB/1.25^{\\circ}$ between adjacent elements in a parabolic distribution locating at the center of the array, the formed beam presents a 1.4dBi main-lobe reduction in the normal direction and an 11.9dBi side-lobe degradation, shown in Fig. 14.7.1. It also shows an active array receiver front-end highlighting all the temperature-sensitive blocks. Calibration can adjust temperature-dependent performances [7]. However, periodic calibration inevitably takes time overhead and prevents array systems from full-time operations. Digital background calibration allows systems to operate uninterrupted, but may induce antenna boresight instability due to abrupt gain/phase change. In contrast, analog background calibration like adaptive healing design can resolve the above issues [8]. In this paper, we present an adaptive analog temperature healing receiver front-end with ± $0.005 dB/^{\\circ}C$ gain variation from -15 to $85^{\\circ}C$ environment temperature for a 17.7-to-19.2GHz phased array.

An L- and C-Band Radiometer Utilizing Distributed Active Hot and Cold Loads With 156% Fractional Bandwidth

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A CMOS fully differential W-band passive imager with <2 K NETD

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

An Adaptive Analog Temperature-Healing Low-Power 17.7-to-19.2GHz RX Front-End with 0.005dB/C Gain Variation, <1.6dB NF Variation, and <2.2dB IP<sub>1dB</sub> Variation across-15 to 85C for Phased-Array Receiver

Broadband Linearity Enhancement Method for a 1.3 GHz-2.5 GHz Digitally-Assisted Oscillator in a 55-Nm CMOS Technology

A 14-B BW /power Scalable Sensor Interface with a Dynamic Bandgap Reference

A 17.7–19.2-Ghz Receiver Front End with an Adaptive Analog Temperature- Compensation Scheme

Design and Implementation of Multiband Noncontact Temperature-Measuring Microwave Radiometer

A Fully Integrated W-Band Four-Channel Silicon-Based Radiometer Array in 65-nm CMOS.

Design and implementation of high sensitivity microwave radiometer

Design and Analysis of a Next-Generation Wide Field-of-View Earth Radiation Budget Radiometer

Design of a two-LNAs-switch-module for biomedical applications in an L-band radiometric system

Performance Characterization of a Fully Transportable Mid-Infrared Laser Heterodyne Radiometer (LHR)

Design and calibration of a cryogenic blackbody calibrator at centimeter wavelengths

Design of a High-Spectral-resolution Lidar for Atmospheric Temperature Measurement Down to the Near Ground.

Design of a Compact Transfer Radiometer for a Radiometric Benchmark Transfer Chain

A Sensitive ALMA Band 10 SIS Receiver Engineering Model

Planck-LFI: Design and Performance of the 4 Kelvin Reference Load Unit

An L -Band Phased Array Radiometer for Sea Surface Salinity in Coastal Zones

Non-scanning Wide Range Multi-Wavelength Imaging Temperature Measurement Technology