A novel deformation measurement method for ablation materials in combustion and ablation process

Xiang Guo,Yingtao Yuan,Tao Suo,Xin Su,Yan Liu,Zhendong Ge

DOI: https://doi.org/10.1016/j.optlaseng.2020.106255

IF: 5.666

2020-11-01

Optics and Lasers in Engineering

Abstract:<p>Ablation material is at the base of the entire aerospace industry. The ablation process is the primary mechanism of thermal protection provided by the ablation material. The mechanical performance of ablation materials across the ablation process is a significant problem for the ablation material research. The combustion phenomenon in the ablation process leads to the failure of the measurement of mechanical properties of materials in the ablation process, which limits the study of mechanical properties of ablation materials. In this paper, a method for the thermo-mechanical coupled deformation measurement is presented. Through the use of filter and light source with a specific wavelength, the high-temperature deformation process of the ablation material specimen from room temperature to 2300K is measured accurately. A new method of speckle feature change matching is presented. The convolution neural network is used to establish the corresponding matching and parameter model between the feature changed speckle feature and the initial speckle feature. The DoG values replace the traditional gray-scale feature for the correlation matching, and the continuous thermo-mechanical coupling deformation of ablation materials is carried out through simulation experiments and actual experiments. The experimental results show that the proposed method can be used to measure and analyze the strain of ablation materials in the process of high-temperature continuous thermo-mechanical coupling deformation.</p>

optics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the technical difficulty of thermodynamically coupled deformation measurement of ablative materials during the combustion process. Specifically, due to flame interference during the combustion process and changes in material surface characteristics, traditional measurement methods are difficult to achieve continuous measurement of the mechanical properties of ablative materials at high temperatures. The paper proposes a new method. By using filters and light sources of specific wavelengths, as well as a new matching algorithm based on convolutional neural networks, accurate measurement of ablative material deformation in the temperature range from room temperature to 2300K has been achieved. This method not only solves the problem of flame interference, but also can effectively deal with the challenges brought by changes in material surface characteristics after combustion, thereby providing technical means for studying the continuous thermodynamically coupled deformation of ablative materials in high - temperature environments. This helps to improve the research on high - temperature mechanical properties and enhance equipment design and safety analysis in high - temperature thermodynamically coupled environments such as aerospace vehicles and aero - engines.