Abstract:Precise prediction of aerothermal loads is significantly limited by the unclear interactions between the thermal protection system surface and the surrounding high-enthalpy gas. To address this, we propose an optical diagnostic method based on optical emission spectroscopy and laser absorption spectroscopy to investigate the gas-surface interactions within the boundary layer. Experiments are conducted in an air plasma flow produced by the 1.2 MW inductively coupled plasma wind tunnel at the China Academy of Aerospace Aerodynamics with enthalpy of 20 MJ/kg and heating time of 100 s. The cylindrical samples made of pure silicon carbide are tested, and quartz samples with the same exposed geometry are tested in parallel as a reference material. The optical emission spectroscopy system has four spectrometers to cover the wide wavelength range 200-1100nm, providing qualitative, spatially-, and spectrally- resolved measurements of the multi-species radiative emission adjacent to the sample surface. Laser absorption spectroscopy is deployed at different axial locations to quantify the number density and translational temperature of OI (3s5S) with a 500 Hz scanning rate and 200 kHz acquisition rate. Additionally, the surface temperature of each sample is detected by an infrared pyrometer. Scanning electron microscopy and energy dispersive spectrometry are performed before and after the plasma heating. Our measurement results provide valuable information on surface reaction pathways and catalytic recombination effects on atomic oxygen number density distributions. Finally, these self-consistent results show that the proposed method is reliable to deeply investigate gas-surface interactions within boundary layer in harsh aerothermal environment.

In Situ Visualization Measurement of Flat Plate Ablation in High-Temperature Gas Flow

Ablation evolution of a new light weight silicon based thermal protection material in high temperature gas flow

Analysis of Weakly Ionized Ablation Plasma Flows for a Hypersonic Vehicle

In-situ 3D Shape and Recession Measurements of Ablative Materials in an Arc-Heated Wind Tunnel by UV Stereo-Digital Image Correlation

Gas-surface interactions in a large-scale inductively coupled wind tunnel investigated by emission/absorption spectroscopy

Experimental study on flow visualization of hypersonic flat plate boundary layer

Measurement of Airblast Atomization of Low Temperature Kerosene with 25 Khz Digital Holography.

Simulation and Application of a New Multiphase Flow Ablation Test System for Thermal Protection Materials Based on Liquid Rocket Engine

3D infrared temperature maps measurements of ablative materials during plasma wind tunnel experiments

Experimental Method Research on Ablation Characteristic of Insulation Material under High Temperature Alumina Droplet Deposition Condition

Experimental Investigation on Heat Flux Measurement of Nozzle Throat

In Situ Observation and Measurement of Composites Subjected to Extremely High Temperature.

In-Situ 3d Shape Measurement System for High-Temperature Object in Plasma Wind Tunnel Via Dmd-Projecting Laser Structured Light and Adaptive Speckle Filtering

Pore scale visualization of thermal-fluid-structural evolution in the ablation of carbon/carbon composites

In situ multi-band apparent emissivity measurements of aerospace materials in inductively coupled plasma flows

Experimental Investigation on Heat Transfer Characteristics of an Annual Jet Flame in a Pore-Array Spray Gun

Particle Image Velocimetry and Total Temperature Characterization of Arc-Heated Mach 4.5 Free Jet

Experimental Study of Hypervapotron under Conditions of High Heat Flux

Study On Temperature Field Measurement Of Plasma Stream During Rapid Sprayed Tooling

In-situ measurement of the droplet temperature, velocity and mass under plasma arc

Effects of ablation products of silicon-based materials on radiation of high-temperature gas flow field