Abstract:—The results of laboratory experiments on concurrent active acoustic and deformation monitoring of a hydraulic fracture are presented. The experiments were carried out in a model material based on gypsum. For comparison, reference experiments were performed to study the propagation of ultrasonic waves through a liquid-filled gap of controlled width between two precision glass plates. The purpose of the experiments was to study the dependence of the amplitude of the ultrasonic wave passing through the fracture on the value of its opening. In these experiments, a circular hydraulic fracture was created with the plane perpendicular to the axis of the cylindrical sample. A cased injection well was located along the same axis, ending at the middle of its height. The sample was placed between two aluminum alloy disks equipped with piezoceramic transducers built into them, operating in both the emitter and the receiver modes. The working liquid was supplied to the fracture through the channel in the lower disk. The sample was saturated with pore fluid through the upper disk. The entire assembly was placed in a hydraulic press providing a constant compressive force. The fracture opening value varied with the flow rate of the liquid supplied to the center of the fracture and was measured by the relative change in the distance between the disks of the assembly using inductive displacement transducers. Experiments were also carried out simulating a fracture filled with proppant. In this case, the fracture aperture varied as a function of the vertical force applied to the sample. Based on the results of experiments carried out under various conditions, the dependences of the amplitude of the ultrasonic wave that passed through the fracture were plotted. It has been experimentally established that sound attenuation in the hydraulic fracture, which has a natural roughness, is twice lower than in the gap between precision glass plates. The obtained results will make it possible to estimate the value of the hydraulic fracture opening in laboratory experiments conducted on larger samples using active acoustic monitoring.

Precursory Signals to Injection Induced Fault Reactivation in the Laboratory Using Active Ultrasonic Monitoring Methods

Estimating the Physical State of a Laboratory Slow Slipping Fault from Seismic Signals

Seismicity triggered by fluid injection–induced aseismic slip

Numerical modeling of low frequency distributed acoustic sensing signals for mixed-mode reactivation

A laboratory perspective on accelerating preparatory processes before earthquakes and implications for foreshock detectability

Co-detection of acoustic emissions during failure of heterogeneous media: new perspectives for natural hazard early warning

A method for monitoring acoustic emissions in geological media under coupled 3-D stress and fluid flow

Laboratory Simulation of Injection-Induced Shear Slip on Saw-Cut Sandstone Fractures under Different Boundary Conditions

Off-fault deformation feedback and strain localization precursor during laboratory earthquakes

Concurrent Active Acoustic and Deformation Monitoring of a Hydraulic Fracture in Laboratory Experiments

Machine Learning Predicts the Timing and Shear Stress Evolution of Lab Earthquakes Using Active Seismic Monitoring of Fault Zone Processes

Noncontacting laser-based acousto-seismics at the laboratory scale: towards near-real-time monitoring of granular analogue models

Kinematic Inversion of Aseismic Fault Slip During the Nucleation of Laboratory Earthquakes

Pre-Failure Strain Localization in Siliclastic Rocks: A Comparative Study of Laboratory and Numerical Approaches

A Wideband Magnetoresistive Sensor for Monitoring Dynamic Fault Slip in Laboratory Fault Friction Experiments

Fault Reactivation Analysis Using Microearthquake Clustering Based on Signal-to-Noise Weighted Waveform Similarity

Automatic Time Step Control to Resolve Hydromechanically Driven Fault Reactivation, Spontaneous Nucleation, and Seismic Arrest

INDUCED SEISMICITY. Seismicity triggered by fluid injection-induced aseismic slip

Fault Weakening During Short Seismic Slip Pulse Experiments: the Role of Pressurized Water and Implications for Induced Earthquakes in the Groningen Gas Field

A laboratory study on fault slip caused by fluid injection directly versus indirectly into a fault: implications for induced seismicity in EGSs

Characterizing Acoustic Signals and Searching for Precursors during the Laboratory Seismic Cycle Using Unsupervised Machine Learning