Noncontacting laser-based acousto-seismics at the laboratory scale: towards near-real-time monitoring of granular analogue models

J Smits,I Vasconcelos,E Willingshofer,F Beekman

DOI: https://doi.org/10.1093/gji/ggae157

IF: 3.352

2024-04-27

Geophysical Journal International

Abstract:Summary In this work we present a novel, experimentally-efficient setup for performing noncontacting laser vibrometry on geologic materials and their analogues. We show it is possible to acoustically monitor a granular material experiment in real time compared to the typical timescale of analogue modeling experiments. We acquire noncontacting waveform data with consistently high signal-to-noise-ratio (SNR). Compared to previously used standard contacting transducers, the novel joint use of sources and receivers that are both laser-based resulted in measured signals with improved waveforms and temporal bandwidths. These data acquisition improvements, in our case where surface waves are prominent in the data, enable enhanced multichannel surface wave processing, e.g., in terms of reliable dispersion curve estimates. We find, given the high waveform fidelity of our acquisition system, that the observed surface waves are highly sensitive to relatively small changes in in the medium’s elastic properties, making them a demonstrably reliable to monitor any processes that affect elasticity in these models in near-real time. As a demonstration, we continuously monitor a scaled analogue model containing granular glass beads. By continuously monitoring - i.e., performing repeatable active-source acousto-seismic surveys at short time-lapse intervals - over a period of ten hours, we find that an increase of relative humidity of 10% can lead to as much as a factor of two increase in surface wave group velocities. Finally, we discuss future applications of the developed method by considering surface wave inversion for fault and stress monitoring during the deformation of a model.

geochemistry & geophysics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to achieve non - contact laser vibration measurement of geological materials and their analogues on a laboratory scale, in order to realize real - time or near - real - time monitoring of the changes of these materials during the experimental process. Specifically, the researchers have developed a new method using lasers as sound sources and receivers to obtain non - contact waveform data with a high signal - to - noise ratio in geological material experiments. This method can significantly increase the data acquisition speed, enabling reliable monitoring on the time scale of rapid changes in the internal structure of materials, which is crucial for understanding geological processes (such as fault formation and stress changes).

The main objectives of the paper include:
1. **Develop an efficient non - contact laser vibration measurement system**: By using lasers as sound sources and receivers, reduce the interference caused by traditional contact - type sensors and improve data quality and time resolution.
2. **Achieve real - time monitoring**: By continuously monitoring geological material simulation experiments, capture the tiny changes in the elastic properties of materials, thereby providing high - precision snapshots of the material state during the experimental process.
3. **Verify the effectiveness of the method**: Verify the sensitivity and reliability of this method under different environmental conditions through experiments, especially its response to humidity changes.

The paper demonstrates the performance of this system through a series of experiments, especially its ability to monitor surface wave propagation and changes in the elastic properties of materials. The experimental results show that this system can reliably detect the influence of relative humidity changes on the surface wave group velocity, thus proving its potential for monitoring geological processes on a laboratory scale.