Abstract:The physical properties of 2D materials can be tuned by doping to extreme charge carrier density, enabling the investigation of phenomena such as superconductivity, charge density waves, band inversion and Lifshitz transitions. For example, it is variably estimated that an electron density of 3.7 − 5.1 × 10 14 cm −2 is required in order to induce a Lifshitz transition in monolayer graphene [1,2]. At this charge density, the Fermi surface passes through the hyperbolic saddle point of graphene at the M-pointin the Brillouin zone, where the Fermi surface geometry changes and the density of states diverges at a van Hove singularity. Achieving charge density sufficient to reach the Lifshitz transition has been limited to chemical doping in ultra-high vacuum (UHV) conditions and observation by angle resolved photoemission spectroscopy (ARPES). Integrating experimental methods for charge transport measurements with UHV chemical doping conditions is typically difficult. Field-effect methods including dielectric gating and ionic liquid gating are readily integrated with charge transport measurements, but achieve lower charge carrier density than UHV chemical doping methods. We report here an integrated flip-chip method to dope graphene by alkali vapour in the diffusive regime, suitable for charge transport measurements at ultra-high charge carrier density. We introduce a liquid cesium droplet source into a sealed cavity filled with inert gas (argon) to dope a monolayer graphene Hall bar on a quartz substrate by the process of cesium atom diffusion, adsorption and ionization at the graphene surface (Fig. a). Doping can be monitored by operando ac Hall measurement of longitudinal R xx and transverse R xy resistance of graphene (Fig. b). An optical image of a representative graphene Hall bar is shown in Fig. c (scale bar = 100 μm). The measured time dependent R xx and R xy during Cs exposure can be used to determine the time dependent electron density n and electron mobility μ . Upon sealing, the flip-chip assembly containing doped graphene is stable in ambient conditions, enabling sample characterization by various means, including non-resonant Raman scattering measurement through the transparent quartz window. Charge transport versus temperature and magnetic field in a variable temperature insert was performed, including Hall measurements to B = 7 T (Fig. d). By these methods, we confirm that flip-chip doping with Cs can be used to achieve charge density exceeding 4 × 10 14 cm −2 . The Lifshitz transition is observed via the inversion of cyclotron effective mass, corresponding to sign inversion of the Hall coefficient R H (Fig. d). Employing a third-nearest-neighbour tight binding (3NNTB) calculation, we estimate the Fermi energies and Fermi surfaces corresponding to the charge densities observed by high field magnetotransport (Fig. e). At the Lifshitz transition, the Fermi surface transforms abruptly from that of electron pockets around the K and K' points, to a hole pocket around Γ. Further experimental observations will be discussed. In summary, our findings show that chemical doping, hitherto restricted to ultra-high vacuum conditions, can be applied in a diffusive regime at ambient pressure in an inert gas environment. We anticipate that our flip-chip doping method can be applied to a variety of 2D materials and dopant speciies beyond monolayer graphene and Cs. [1] P. Rosenzweig et al., "Overdoping graphene beyond the van Hove singularity", Physical Review Letters 125, 176403 (2020). [2] A. Zaarour et al., "Flat band and Lifshitz transition in long-range-ordered supergraphene obtained by Erbium intercalation. Physical Review Research 5, 013099 (2023). Figure 1

Ultrahigh Doping of Graphene Using Flame-Deposited MoO3

Hole Doping In Epitaxial Mose2 Monolayer By Nitrogen Plasma Treatment

Strong and Stable Doping of Carbon Nanotubes and Graphene by MoOx for Transparent Electrodes.

Improving chemical vapor deposition graphene conductivity using molybdenum trioxide: An in-situ field effect transistor study

Analysis of p -Type Doping in Graphene Induced by Monolayer-Oxidized TMDs

In Situ Oxygen Doping of Monolayer MoS2 for Novel Electronics.

Low pressure chemical vapor deposition synthesis of large area hetero-doped mono- and few- layer graphene with nitrogen and oxygen species

Stable p-type chemical doping of graphene with reduced contact resistance by single-layer perfluorinated polymeric sulfonic acid

Wafer-Scale Oxygen-Doped MoS2 Monolayer.

(Invited) High-Density, Flip-Chip Alkali Doping of Graphene and Observation of the Lifshitz Transition

Doping Monolayer Graphene with Single Atom Substitutions

Wafer‐Scale Oxygen‐Doped MoS 2 Monolayer

Microwave graphitic nitrogen/boron ultradoping of graphene

Control of Doping by Matrix in Few-Layer Graphene/metal Oxide Composites with Highly Enhanced Electrical Conductivity

Facile P-Doping of Few-Layer MoTe2 by Controllable Surface Oxidation Toward High-Performance Complementary Devices

Programmable graphene doping via electron beam irradiation

Tunable Doping Strategy for Few-Layer MoS2 Field-Effect Transistors via NH3 Plasma Treatment

A molecular understanding of the gas-phase reduction and doping of graphene oxide

High-performance monolayer MoS2 field-effect transistor with large-scale nitrogen-doped graphene electrodes for Ohmic contact

Low-Temperature Growth of Large-Area Heteroatom-Doped Graphene Film

Dry transfer of CVD graphene using MoS$_2$-based stamps