Abstract:High-altitude environments are characterized by low air pressures and temperature variations. Low-heat Portland cement (PLH) is a more energy-efficient alternative to ordinary Portland cement (OPC); however, the hydration properties of PLH at high altitudes have not been previously investigated. Therefore, in this study, the mechanical strengths and levels of the drying shrinkage of PLH mortars under standard, low-air-pressure (LP), and low-air-pressure and variable-temperature (LPT) conditions were evaluated and compared. In addition, the hydration characteristics, pore size distributions, and C-S-H Ca/Si ratio of the PLH pastes under different curing conditions were explored using X-ray diffraction (XRD), thermogravimetric analysis (TG), scanning electron microscopy (SEM), and mercury intrusion porosimetry (MIP). Compared with that of the PLH mortar cured under the standard conditions, the compressive strength of the PLH mortar cured under the LPT conditions was higher at an early curing stage but lower at a later curing stage. In addition, drying shrinkage under the LPT conditions developed rapidly at an early stage but slowly at a later stage. Moreover, the characteristic peaks of ettringite (AFt) were not observed in the XRD pattern after curing for 28 d, and AFt transformed into AFm under the LPT conditions. The pore size distribution characteristics of the specimens cured under the LPT conditions deteriorated, which was related to water evaporation and micro-crack formation at low air pressures. The low pressure hindered the reaction between belite and water, which contributed to a significant change in the C-S-H Ca/Si ratio in the early curing stage in the LPT environment.

Rheology and air entrainment of fresh Portland cement mortars in simulated low air pressure environments

Rheological properties of mortar and concrete with low binder content

Microstructural changes of young cement paste due to moisture transfer at low air pressures

Effect of the entrained air void on strength and interfacial transition zone of air-entrained mortar

Early-age Shrinkage Behavior of Cement-Fly Ash Paste under Wind Speeds: A Study Using BSE-IA and MIP Techniques

Characteristic Analysis of Air Bubbles on the Rheological Properties of Cement Mortar

Effect of nanomaterials on the mechanical properties and microstructure of cement mortar under low air pressure curing

Experimental investigation on fractal characteristics of pores in air-entrained concrete at low atmospheric pressure

Simulation Analysis of Pumping Characteristics for High-Altitude Concrete

Chloride Ingress Profiles and Binding Capacity of Mortar in Cyclic Drying-Wetting Salt Fog Environments

Effect of low air pressure on the durability of concrete

Physical Properties and Hydration Characteristics of Low-Heat Portland Cement at High-Altitude

Physical and Chemical Influence of Polyacrylate Latex on Cement Mortars

Influence of Sand-Cement Ratio and Polycarboxylate Superplasticizer on the Basic Properties of Mortar Based on Water Film Thickness

Investigation on air-voids structure and compressive strength of concrete at low atmospheric pressure

Study on the rheological properties of Portland cement pastes with polycarboxylate superplasticizers

Development of Pore Pressure in Cementitious Materials under Low Thermal Effects: Evidence from Optimization of Pore Structure by Incorporation of Fly Ash

Characteristic Analysis of Concrete Air Entraining Agents in Different Media

Rheology, bubble-particle interaction and air bubble system: A study of the influence of inorganic salts on air entrainment by bubble rising measurement

Investigation on Hydration and Mechanical Properties of Mortar Containing Limestone Powder and Fly Ash Based on the Coupled Chemical–Thermal–Mechanical Method

Influences of Air-Voids on the Performance of 3D Printing Cementitious Materials