2D XBiSe3(X = As, Sb) monolayers with high anisotropic mobility and enhanced optical absorption in visible light region

Li-Bo Zhan,Chuan-Lu Yang,Mei-Shan Wang,Xiao-Guang Ma

DOI: https://doi.org/10.1016/j.apsusc.2020.147137

IF: 6.7

2020-11-01

Applied Surface Science

Abstract:<p>Configurations and properties of 2D XBiSe₃(X = As, Sb) monolayers are predicted by first-principles calculations. Dynamic and thermal stabilities are affirmed by phonon dispersion and <em>ab initio</em> molecular dynamics simulation, respectively. Bandgap and band edges, density of states, optical absorptions, and mobilities are calculated by using the obtained structures. Effects of strain engineering on the band structure and optical absorption are also explored. Results reveal that the AsBiSe₃ and SbBiSe₃ monolayers have indirect gaps of 1.2 eV (HSE06)/1.43 eV (GW) and 1.1 eV (HSE06)/1.32 eV (GW), respectively. The high electron (approximately 10⁵ cm²V⁻¹s⁻¹) and hole (approximately 10⁴ cm²V⁻¹s⁻¹) mobilities of the XBiSe₃ monolayers are observed for zigzag and armchair directions, and obvious anisotropy is observed. The intense optical absorptions in the UV–visible light regions are identified for the two monolayers. Interestingly, the band edge of the AsBiSe₃ monolayer can span the redox potential of water under −4% biaxial compressive strain, which implies that this monolayer can be used as a candidate material for photocatalytic water splitting to produce hydrogen. All the results support the assertion that the XBiSe₃ monolayers have potential for application in the optoelectronic, photocatalytic, and photovoltaic fields.</p>

chemistry, physical,physics, applied, condensed matter,materials science, coatings & films

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to explore the geometric structure, electronic properties and optical properties of 2D XBiSe3 (X = As, Sb) monolayer materials, and evaluate their application potential in the fields of optoelectronics, photocatalysis and photovoltaics. Specifically, the researchers predicted the dynamic and thermal stabilities, properties such as band gap, band edge position, density of states, optical absorption and carrier mobility of these monolayer materials through first - principles calculations, and explored the influence of strain engineering on these properties. The main objectives of the study include:

1. **Confirm the stability and basic properties of materials**: Verify the dynamic and thermal stabilities of XBiSe3 (X = As, Sb) monolayer materials through calculations, as well as their basic electronic and optical properties, such as band gap, density of states and optical absorption.

2. **Evaluate carrier mobility**: Calculate the electron and hole mobilities of XBiSe3 (X = As, Sb) monolayer materials in different directions to evaluate their application potential in optoelectronic devices.

3. **Explore the influence of strain engineering**: Study the changes in band gap, band edge position and optical absorption of materials under different strain conditions (including tensile strain and compressive strain) to determine whether these materials can optimize their photoelectric properties through strain modulation.

4. **Evaluation of potential applications**: Based on the research of the above properties, evaluate the application potential of XBiSe3 (X = As, Sb) monolayer materials in the fields of optoelectronics, photocatalysis (especially photocatalytic water - splitting for hydrogen production) and photovoltaics.

Through these studies, the paper aims to provide a theoretical basis and experimental guidance for the development of new two - dimensional materials and their applications in clean energy technologies.