Abstract:We demonstrated a new optical fiber modal interferometer (MI) for airflow sensing; the novelty of the proposed structure is that an MI is fabricated based on a piece of HAF, which makes the sensitive MI itself also a hotwire. The interferometer is made by applying arc-discharge tapering and then flame tapering on a 10 mm length high attenuation fiber (HAF, 2 dB/cm) with both ends spliced to a normal single mode fiber. When the diameter of the fiber in the processing region is reduced to about 2 μm, the near-infrared dispersion turning point (DTP) can be observed in the interferometer's transmission spectrum. Due to the absorption of the HAF, the interferometer will have a large temperature increase under the action of a pump laser. At the same time, the spectrum of the interferometer with a DTP is very sensitive to the change in ambient temperature. Since airflow will significantly affect the temperature around the fiber, this thermosensitive interferometer with an integrated heat source is suitable for airflow sensing. Such an airflow sensor sample with a 31.2 mm length was made and pumped by a 980 nm laser with power up to 200 mW. In the comparative experiment with an electrical anemometer, this sensor exhibits a very high air-flow sensitivity of −2.69 nm/(m/s) at a flowrate of about 1.0 m/s. The sensitivity can be further improved by enlarging the waist length, increasing the pump power, etc. The optical anemometer with an extremely high sensitivity and a compact size has the potential to measure a low flowrate in constrained microfluidic channels.

High Sensitivity Flow Velocity Sensor Based on All-Fiber Target-Type Structure

Initial approach for all optical type silicon micro-mechanical flow sensor

Bio-inspired flow rate sensor based on optical microfiber embedded soft film

A Miniature Liquid Flowmeter Using All-Fiber Fabry–Perot Cavity for Real-Time Measurement

Novel Integrated Optical Fiber Sensor for Temperature, Pressure and Flow Measurement

Dispersion Turning Attenuation Microfiber for Flowrate Sensing

Novel target type flowmeter based on a differential fiber Bragg grating sensor

A Transparent Flow Velocity Sensor of Ultra-thin Glass Fabricated by Femtosecond Laser Processing

Fiber-optic Integrated Aerodynamic Three-Hole Vector Probe for High-Velocity Flow Field Measurement

Optical Fiber Based Microfluidic Gas Flowmeter

Research on High Sensitivity Optical Fiber Sensing Method for Simultaneous Measurement of Seawater Velocity and Temperature

Microfluidic Flowmeter Based on Micro "Hot-Wire" Sandwiched Fabry-Perot Interferometer.

An Integrated Interferometric Fiber Optic Sensor Using a 638 nm Semiconductor Laser for Air-Water Surface Velocity Measurements

Highly Sensitive Airflow Sensor Based on Fabry–Perot Interferometer and Vernier Effect

Bioinspired Fiber-Optic Vector Flow Sensor Based on Enhanced Vernier Effect for Marine Sensing

Fabrication and characterization of high-sensitivity, wide-range, and flexible MEMS thermal flow velocity sensors

High-sensitivity gas pressure sensor based on a multimode interferometer using hollow-core tube lattice fiber

An optical fiber sensor for simultaneous measurement of flow rate and temperature in the pipeline

Dual-Mode Fiber Optofluidic Flowmeter with A Large Dynamic Range

Ultrasensitive all-fiber inline Fabry-Perot strain sensors for aerodynamic measurements in hypersonic flows

Highly-sensitive temperature sensor based on photopolymerized-waveguide embedded Mach-Zehnder interferometer