Investigation of Surface Integrity of Selective Laser Melting Additively Manufactured AlSi10Mg Alloy under Ultrasonic Elliptical Vibration-Assisted Ultra-Precision Cutting

Rongkai Tan,Xuesen Zhao,Qi Liu,Xianmin Guo,Fengtao Lin,Liquan Yang,Tao Sun

DOI: https://doi.org/10.3390/ma15248910

IF: 3.4

2022-12-13

Materials

Abstract:Additive manufacturing technology has been widely used in aviation, aerospace, automobiles and other fields due to the fact that near-net-shaped components with unprecedented geometric freedom can be fabricated. Additively manufactured aluminum alloy has received a lot of attention, due to its excellent material properties. However, the finished surface of additively manufactured aluminum alloy with nanoscale surface roughness is quite challenging and rarely addressed. In this paper, a novel machining technology known as ultrasonic elliptical vibration-assisted cutting (UEVC) was adopted to suppress the generation of cracks, improve the surface integrity and reduce tool wear during the ultra-precision machining of selective laser melting (SLM) additively manufactured AlSi10Mg alloy. The experimental results revealed that, in the conventional cutting (CC) process, surface defects, such as particles, pores and grooves, appeared on the machined surface, and the machined surface rapidly deteriorated with the increase in cumulative cutting area. In contrast, an almost flawless machined surface was obtained in the UEVC process, and its roughness value was less than 10 nm. Moreover, the tool wear of the CC tool was remarkably greater than that of the UEVC tool, and the standard flank wear width of the CC tool was more than twice that of the UEVC tool. Therefore, the UEVC technology is considered to be a feasible method for the ultra-precision machining of SLM additively manufactured AlSi10Mg alloy.

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to improve the surface integrity and reduce tool wear in ultra - precision machining of AlSi10Mg alloy fabricated by selective laser melting (SLM) through ultrasonic elliptical vibration - assisted cutting (UEVC) technology. Specifically, the research aims to:

1. **Suppress crack generation**: Reduce the cracks generated during the machining process through UEVC technology and improve the surface integrity of the material.
2. **Improve surface quality**: Compared with conventional cutting (CC), UEVC technology can significantly reduce the surface roughness and greatly reduce surface defects such as particles, holes and grooves.
3. **Reduce tool wear**: UEVC technology can significantly reduce tool wear and extend tool life.

The paper verifies the superiority of UEVC technology in these aspects through experiments, especially the improvement effect on the surface quality and tool life of AlSi10Mg alloy fabricated by SLM in ultra - precision machining. The experimental results show that during the CC process, a large number of particles, holes and grooves appear on the machined surface, and the surface roughness value is relatively high; while during the UEVC process, the machined surface has almost no defects, the surface roughness value is less than 10 nm, and the tool wear is significantly reduced. Therefore, UEVC technology is considered to be a feasible method for ultra - precision machining of AlSi10Mg alloy fabricated by SLM.