Abstract:In piezo acoustic drop-on-demand inkjet printing a single droplet is produced for each piezo driving pulse. This droplet is typically multicomponent, including surfactants to control the spreading and drying of the droplet on the substrate. However, the role of these surfactants on the droplet formation process remains rather elusive. Surfactant concentration gradients may manifest across microsecond-to-second timescales, spanning both the rapid ejection of ink from the nozzle exit and the comparatively slower idling timescale governing the firing of successive droplets. In the present work, we study the influence of surfactants on droplet formation across 6 orders of magnitude in time. To this end, we visualize the microsecond droplet formation process using stroboscopic laser-induced fluorescence microscopy while we vary the nozzle idle time. Our results show that increasing the idle time up to O(1) s affects only the break-up dynamics of the inkjet but not its velocity. By contrast, for idle times $>$ O(1) s, both the break-up dynamics are altered and the velocity of the inkjet increases. We show that the increased velocity results from a decreased surface tension of the ejected droplet, which we extracted from the observed shape oscillations of the jetted droplets in flight. The measured decrease in surface tension is surprising as the $\mu$s timescale of droplet formation is much faster than the typical ms-to-s timescale of surfactant adsorption. By varying the bulk surfactant concentration, we show that the fast decrease in surface tension results from a local surfactant concentration increase to more than 200 times the CMC. Our results suggest that a local high concentration of surfactant allows for surfactant adsorption to the interface of an inkjet at the $\mu$s-to-ms timescale, which is much faster than the typical ms-to-s timescale of surfactant adsorption.

Mist Generation Behavior in Ultrasonic Atomizer for Aerosol Jet® Printing

Mist Generation Behavior in Ultrasonic Atomizer for Aerosol Jet Printing

Measurement of Atomization Characteristics on Water Mist Fire Suppression Nozzle

Mist Flow Visualization for Round Jets in Aerosol Jet Printing

Electric Field-Assisted Droplet Formation Using Piezoactuation-Based Drop-On-Demand Inkjet Printing

In-Situ Qualification and Physics-Based Process Design for Aerosol Jet Printing via Spatially Correlated Light Scattering Measurements

Three-Dimensional Simulation Of Effervescent Atomization Spray

Selective Evaporation at the Nozzle Exit in Piezoacoustic Inkjet Printing

Design and experimental setup of a new concept of an aerosol-on-demand print head

Numerical study on the atomization mechanism and energy characteristics of synthetic jet/dual synthetic jets

In-Flight Imaging of Aerosol Jet Printer Droplets to Enable Spatially Resolved Flow Rate Measurements

Spray characteristics of an ultrasonic microdroplet generator with a continuously variable operating frequency

Aerosol jet printing of surface acoustic wave microfluidic devices

Droplet Volume Modulation Based on Multi-Waveform Superposition for Drop-on-demand Material Jetting

An Extensive Study of the Influence of Key Flow Variables on Printed Line Quality Outcomes during Aerosol Jet Printing Using Coupled Three-Dimensional Numerical Models

Experimental Investigation of Surface Acoustic Wave Atomization

Role of surfactants on droplet formation in piezoacoustic inkjet printing across microsecond-to-second timescales

An Experimental Study of Atomization Characteristics of the Ultrasonic Spray Nozzle

Reduction Of Droplet Volume By Controlling Actuating Waveforms In Inkjet Printing For Micro-Pattern Formation

Possible, impossible, and expected diameters and production rates of droplets in aerosols and sprays

A Comprehensive Investigation of Process Parameters and Material Properties Effects on Printed Line Quality of Aerosol Jet Printing Based on Coupled Three-dimensional Numerical Models